1 set of replacement filters with following :
8 x Sediment Filter 5 micron Dirt/Rust remover
Size 9 7/8 inch x 2.5 inch - Fits most standard 10 inch size housings and most reverse osmosis systems.
Used to remove larger particles & suspended matter such as dirt, silt, rust, sand, algae, sediment, scale particles, and cloudiness from water.
Meets FDA requirements for food and beverage contact.
No leachable or extractable material to contaminate outflowing water.
Long life and increased dirt holding capacity.
No surface binders to reduce flow and increase change-out frequency.
6 x GAC 10 Inch Coconut shell Carbon Filter
Size 9 7/8 inch x 2.5 inch - Fits most standard 10 inch size housings and most reverse osmosis systems.
Remove Chlorine, Turbidity, Bad Taste & Odor, Sediment, Dirt, and THMS from water.
Thick Wall Coconut Base Carbon Filter Media - 100% coconut shell carbon Designed For maximum contact between the water and carbon.
Filter membrane included to prevent carbon fines to pass from the filter to your drinking water.
Operation Temperature: 40°F to 125°F
8 x Cation Resin Cartridge Filters
Size 9 7/8 inch x 2.5 inch - Fits most standard 10 inch size housings and most reverse osmosis systems.
Filter Media: Cation Resin
Capacity : 750 grains
Maximum Recommended Flow Rate: 2.5 to 5 GPM (depends on incoming water pressure).
Operational Temperature Range: 40°F to 100°F
Maximum pressure: 125 PSI (8.6 bar)
Minimum pressure: 20 PSI (1.4 bar)
5-Micron nominal rating.
Cartridge capacity dimensions - ID: 30mm OD: 70mm
Reduces Total Dissolved Solids (TDS) and hardness, can also be used as a pre-filter to prevent build-up of scale on sensitive equipment.
End Caps: Polypropylene
Inner/Outer Wraps: Polyolefin
Netting: Polyethylene
Total 22 filters, each individually wrapped.