BMX Freestyle Brake Cable Kit to install a front brake via a Potts Mod and a rear brake with a single cable rotor (such as an ACS rotor). This kit is for a rotor - NOT a gyro.

This is a CUT-TO-FIT kit. Be sure you have good quality STEEL cable cutters.

Here is what you get:

• 7 feet of lined cable housing in ORANGE. This is plenty of housing for both a front and rear brake *if* you measure carefully before cutting.
  
• 6 nickel plated brass cable housing ferrules (NOT cheap steel ones that can rust)
• 2 aluminum old school-style brake lever ferrules (also known as end buttons - for non-threaded brake levers such as MX122, Tech 2, Tech 3, Tech 4 and Tech 6)
• 1 brake cable 1.5mm X 1700mm (65") - this is for the front brake
• 1 brake cable with one normal barrel knarp (for rear brake lever to rotor) and the other end a road bike knarp (from rotor to the rear brake). This cable is 1.5mm X 3070mm (121") and is then cut to make the two cables needed to install the rotor.
  
• 3 cable end tips

Want to make your own kit? We sell all components separately as well as the cable housing by the foot on our website. We also have options for , anodized end buttons, end tips, etc. - EXCLUSIVELY in the kits on our website.

IMPORTANT: There is no substitute for MEASURING your bike before ordering. While there are some rule of thumb standard for bikes from a specific era, there are no absolutes.  Save yourself time and money and MEASURE first, order once.

We have over 2500 old school and retro BMX products (as well as hard to find stuff for other types of bikes) on our website. If you don't see what you're looking for here, there's a good chance we have it there.