This
is a set of 10 Chrysler factory correct thread cutting nuts that are used in various places on the car such as emblems, to dash, interior panels and also replaces the old nuts
on original metal trim clips that attach the trim molding to your
car.
These nuts are correct for a non threaded stud that is 1/8" in diameter and intended for a thread cutting nut just like Chrysler used (please see referenced picture). These nuts cut threads into the non threaded stud as you spin it on and exhibit the correct 5/16" hex head with a 3/4" washer just like the factory used. The picture of
the clips is for reference only. You will only get 10 nuts. These were
used on many years of different Chrysler models from the 50s through the 70s. Chrysler used these
nuts on many different makes and models of car and trucks. Do not go off of the compatibility chart as it may not be correct. Please look at the photos and be sure that the nuts you need look like and measure like the ones listed.
I do have other styles and sizes of
nuts that are also used by Chrysler so if this one is not correct for you
please see my other listings in my ebay store. The original nuts are
always very rusty and often broken or lost when removed. Now you can
get your vehicle back to original showroom standards with this this new
nut
kit. I am
a seller of the products I use. These are the same nuts that I use on
my award winning concourse restorations here at Midwest Muscle Car
Specialties so bid with confidence.