3D Printed Honda DC5 Integra Gauge Holder for 60mm Gauges.
A custom designed 3D Printed gauge holder designed to take a 60mm diameter gauge that can be mounted in place of the OEM air vent to the left of the steering wheel on RHD cars.
To fit you will need to carefully pry off the heater control panel (it is recommended to use thin plastic pry bars to prevent damage to the panel), once removed you will need to disconnect the wiring harness from the back of the heater control module. Using a Philips head screw driver remove the 2 screws holding the air vent in place, swap in the gauge holder and use the two screws to fasten the holder into place. You are now free to install your gauge and re-fit the panel.
If you need a holder to fit a special gauge size please get in touch.
| Part Specification |
| To fit 60mm diameter Gauges. |
| 3D Printed using a commercial grade Stratasys F270 3D Printer. |
| Printed in super strong ABS+ material. |
| Fits in place of the original air vent to the left of the steering wheel (RHD). |
| Mounts using the original air vent screws. |
ATTENTION
- We offer this holder in two sizes, please see our other eBay listing for the 52mm size.