**please download the guide listed below before making a purchase and make sure your printer is using the same main board as shown in the guide**  

IT IS NOT FOR THE CR-10s or any of the printers with the Mega2560 board.. please make sure you check before buying!   

here we have a highly anticipated mod which had been requested so much by the community on facebook. you wanted an affordable solution for this very popular printer.. and now im happy to say i can deliver. :)

Skynet3Dmods is proud to present...

Creality CR-10 Autobed levelling kit

I've already sold many sensors for the Anet brand printers but the Creality community have specifically stated that they required a kit which included everything needed to get going with auto bed leveling... they wanted it to be easy to install.. with a comprehensive -easy to follow- guide.. i have listened.. enjoy!

Contents of the kit!

- The capacitive sensor itself (this is in 2 parts so that you can route the cable into the cr-10 control box) it comes with a harness to safely power the sensor with 12v whilst only sending a 5v signal to the CR-10 Melzi board.
- Boot loader flashing tool
- Creality Bootloader adapter
- 3d printed sensor mount

** no useless over priced 3d printed parts
** no useless stickers
** no need to buy any other hardware
** no charge for open source firmware
**Sensor mount is compatible with the fang cooler upgrade

Just everything you need in one package.
All kits are hand made in my small home workshop and tested on my own Standard CR-10 printer with and autohome and autolevel command prior to sale.

Full installation instructions can be downloaded here- https://drive.google.com/open?id=0B0Jb9SruV4vGVndyYXV3Mm9GTlE

as with all items in my store;

items will be shipped by royal mail once i've received full payment

WORLDWIDE SHIPPING (including but not limited to)  
UNITED STATES OF AMERICA
CANADA
AUSTRALIA
EUROPEAN UNION

please make contact before leaving negative feedback should a problem arise and allow me the chance to resolve any issues.

happy printing and enjoy :)

Disclaimer

i take no responsibility if you decide to modify your printer from its stock form. you do so fully at your own risk. im here to provide support should you need it and all my kits are tested fully before dispatch so if for some reason you brick or blow up your printer or whatever.. on your head be it. Do not attempt to modify your machine if you are not confident in doing so.. and also please do not attempt if you don't have basic knowledge of using your printer in its stock form!

thanks and happy printing