For International and European shipping including NI, Channel Islands and Scotland,

 Please request a shipping quote, prior to buying.

Please read the full description - Actual Picture of Part

You are looking at New Escort Mk 1 clock facia to fit the AVO range of vehicles,

 with black facia and chromes outer and inner rings.

These are brand new - And NOT re chromed parts.

This offer is just the plastic Binnacle and nothing more, see how easy it is to swap your old Binnacle below:

Step by step "How to guide"

So you have your old clocks and want to change the Binnacle to improve the interior look of your car, follow these simple steps and it should take 

no longer than a couple of minute.

1. Get your tools out, you'll need the following:

a. Small electrical Philips screw driver to remove the 10 screws securing the binnacle to the dash and the clocks at the back of the dash.

b.  Glass cleaner and a nice clean cloth.

c.  Glue or clear tape - to refit the ignition and indicator cover plates.

 2. There are 4 x phillips screws that secure the clock binnacle to the dash pad and these need to be removed to free the binnacle.

3.  Once removed take care when pulling the binnacle forward as you will need to get to the back of the clocks to reveal the following:

a. Black line - (oil feed pipe) remove from clocks 

b. Red line (speedo cable) remove from clocks 

c. Pink line (wiring loom) disconnect from main connector

You can actually change the facia without disconnecting anything if you wish, but it's quite difficult.

4.  Once the clocks are free from the connectors above lay the clocks face down on a smooth surface.

a. You now need to remove the 6 x secruing screws that retain the plastic Binnacle to the clock housing - there are 6 x small phillips screws

shown below in red

b.  Once these have been removed the metal part of the dash will come free - take care not to break the glass here

You should now have the following bits in front of you 

a. Old binnacle

b. New binnacle

c. Clock facia glass

d. 2 x cardboard tubes, light illuminators and rubber connectors

e. 10 x screws for dash and binnacle

d. clocks in metal pressing 

See below

Time to clean a few items, such as the glass - a nice spray of glass cleaner will do the trick here

a. remove the colour coded ignition and indicator coves shown here, and re - glue to new facia

b. refit the cardboard light illuminators 

c. reposition the cleaned glass and then fit new binnacle to the clock metal pressing, in reverse order - it's as easy as that

See below

Any questions please feel free to contact us via eBay