R&G Racing AFTERMARKET Classic Crash Protectors CP0147BL
MOUNTING POSITION - TOP ENGINE MOUNT
NO MOFIDICATION REQUIRED TO INSTALL
4 BUNGS IN TOTAL
With
bespoke designs for over 350+ models of motorcycle there is bound to be
an application for your bike. These are not "mushrooms"! Unlike most of
our competitors, we use de-embrittled high-tensile steel bolts which
are designed to bend on impact rather than to shear or snap. In
addition, we add compression sleeves inside the bobbins which
are designed to allow the retaining bolts to be torqued to the correct specification and not to work loose though vibration.
fitting
OFF SIDE (RIGHT SIDE AS YOU SIT ON BIKE)
• Remove RHS fairing
• Remove front engine bolt
• Remove rear engine bolt
• Take the long bar with the 2 tapped holes closest together and slide up behind the electrics curved end
towards the rear and bar to the top
• Take 1 of the longest bolts slide washer over bolt
• Take 1 of the 15mm long spacers and fit between bar and frame sliding the bolt through the bar spacer and
frame (rear engine mount)
• Using the oem nut do up finger tight
• Take 1 of the 110mm long cap head bolts and slide washer over bolt
• Take 1 of the 15mm long spacers and fit between bar and frame sliding the bolt through the bar spacer and
frame (front engine mount)
• Using the oem nut tighten fully
• Tighten the rear nut fully
• Take the l shaped block and fit to the bar using the 2 m10x50 cap head bolts with washers under the heads
note the tapped hole points down and tighten
• Refit fairing
• Take 1 of m10x100 lg hex head bolts and slide washer up to head put bolt through 1 of the bobbins with a
neck then slide through spacer 24mm diax24mm long and tighten into l shaped block
• Take 1 of the m12 x100mm lg hex head bolts and slide washer up to head put bolt through 1 of the bobbins
without neck and tighten to bar using tapped hole to the rear of the fairing
• Repeat for lhs except curved end faces forward with the bar at the bottom
• The 15mm long spacer goes between frame and bar at the front
• The 21mm long spacer goes between frame and bar at the rear