New Märklin Mobile Station 2 replacement cord/ cable.

Fresh from Germany, ships fast from US!

To replace the cord one must remove the five T-8 torx head screws securing the two piece housing together.

Accessing the screws requires removal of the round control knob by gently pulling it away from the controller. On the back side remove the two rubber feet from the base to access the other four screws.

Carefully remove the old cord from the circuit board and install the new one, reassemble and your done!

Note that the rubber feet are differently coded for right and left when replacing.

I also recommend using a good quality T-8 torx bit as the screws sometimes do require a good bit of torque to tighten the two halves completely back together.