For International and European shipping including NI, Channel Islands and Scotland,

 Please request a shipping quote, prior to buying.

Switch Outer Housings with Printed Rocker

as fitted to the MK 1 Mexico Sport and RS1600

that includes the following: 

 1. Head Light housing – remanufactured with the correct curved housing and complete with a decaled rocker  

2.Heater / Fan switch – remanufactured twin position switch Housings, complete with decaled rockers 

3. Wiper switch – remanufactured twin position or single position switch housing  with decaled rocker 

4. Hazard switch – remanufactured single position switch housing with decaled rocker 

5. Heated rear window switch - remanufactured with the correct housing and with the orange insert and correct printed decal 

6. Switch Panel Blanking Plate  

The decal is as per the Ford original items being directly printed, not a sticker and these are all new parts

not re chromed outer housings and polished rockers

Its as easy as one, two, three and you no longer need to send your switches away

1. Get your tools out, you'll need the following

a. Wire wool to clean your connectors

b. Small electrical screw driver to remove the back electrical connector 

2. Once your old switch has been removed from your loom,  lay both switches out on the table ready to swap components, like below

3. Lay your old switch out on the table and applying lite pressure from behind the connectors taking care not to damage the black connector

separate the connector from the switch housing taking care as there is a spring built into the yellow or white block slider block

4. Now lay all of your components out on the table so you know how they go back, pay attention to the position of the slot on the little yellow spring connector pic 2 as the slot aligns with the 

black rocker in pic 3 below

 5. Now take some time cleaning the electrical connectors so they look like this - wire wool is superb for this, ensure you do both sides to finish the job

6. Also take time to clean the side spring clips prior to refitting

7. Re-assemble the switch in reverse order so it looks like this with the side retaining clips in place

8. Refit the switch back onto your loom

Switch housing kits can be bought as a kit or individually as priced above