Simply plug this Dr Mad Thrust V1 switch it into your receiver and you instantly have an on off switch controlled by any channel on your radio.
This small lightweight electronic switch is extremely handy for switching on and off auxiliary functions on all sorts of models.
Connect it to your flap or gear channel for an instant on/off switch!
Plug the single lead into one of your spare channels for switching lights, LEDs, bomb dropping, smoke systems, canopy operation and other low current applications.
The possibilities are endless!
Important:
Your radio must support end point adjustment as you may need to change the end points for this switch to see the desired signal.
As all radios are different you will need to program the related channel end point travel to + - 100% in your radio.
If the switch does not function with these settings you will need to begin reducing the end points around 5% at a time until the switch can detect the min & max travel for the chosen channel.
Note:
The switch works with almost all radios that support End Point adjustment. However we have been informed by our customers that this switch will not work with the following radios:
* Carson Reflex
* Dumborc
* Dumborc
All switches are fully tested before shipment so if yours will not operate with your radio, please contact us.
If two or more switches are purchased they must be set up independently
meaning that and end point settings for one switch may not work for another.
Specification:
Input Voltage: 4.8~7.4v
Specification:
Input Voltage: 4.8~7.4v
Output Voltage: 4.8~7.4v
Maximum Current: 2amps
Length: 30mm
Width: 13mm
Height: 3mm
Weight: 7g
Input Cable: 21cm (JR type plug)
Output Cable: 20cm (JR type socket)
Maximum Current: 2amps
Length: 30mm
Width: 13mm
Height: 3mm
Weight: 7g
Input Cable: 21cm (JR type plug)
Output Cable: 20cm (JR type socket)