Utilising a 3-axis gyro, the NX3 Pro Flight Stabiliser is the new generation of 3-axis aircraft gyros and is capable of stabilising flight on just about any fixed wing aircraft including V-tail & Delta models.
It also offers three different flight modes, Gyro off mode, Rate Mode, Hold Mode. These can be switches in flight via a spare 3 way switch on your radio.
It provides added stability by automatically correcting the aileron, elevator and rudder channels in flight. This compensates for unwanted changes in the aeroplane's attitude due to wind and other factors. In short, it makes your aeroplane much more stable in flight!
The NX3 Pro is great for those who tend to fly in windy conditions, as it will compensate for wind gusts that would normally push your model around. It's also an ideal add-on to your favourite FPV model to keep it on the straight and level while flying.
This unit is very simple to install and use. The adjustable gain settings are pre-set to 50% offering mild stabilisation. You can easily adjust the gain for each channel as desired to increase or decrease the compensation for the respective channel (AIL, ELE, RUD).
Specs:
Input voltage: DC5 - 6V - Can be directly connected to the ESC's BEC power supply
Operating Current: 18mA
Working temperature: -20 Celsius to 85 Celsius
Dimensions: 25 × 40mm
Net Weight: 6.5g
Features
Independent potentiometer adjust for different axis sensitivity
Four Model Types supported: single aileron, dual ailerons , flapperons, delta and v-tail
Three-mode switched from controller:
- Rate Mode - Rate Mode for offset correction.
- Hold Mode - HOLD mode for attitude hold
- Gyro Off Mode - transmitter controls the plane directly
Micro design, small size, supports single aileron model, V-tail model, delta wing model and dual aileron (flaperons) aircraft - Can also be used for 2 - axis on jets using 2 servos for ailerons and a servo on the elevator or if the jet uses 2 servos only, one serving the left aileron and elevator, and the other servo serving the right aileron and elevator, it can be set to a delta wing.
Package Includes
x1 NX3 Pro flight stabiliser
x5 Male to male servo Leads
x1 user manual
Double sided mounting pads
Small screw driver for potentiometer adjustments
Please Note:
The NX3 Pro has to re-learn centre position after installation, or replacing a new radio system, or making a trimming or Sub-Trim change within the transmitter, otherwise the servos may move to one side automatically when switching to hold mode.To do this,just quickly flip the flight mode switch twice between rate mode and hold mode within 1 second!