This Collet Stop was designed for use with the Eagle 210 Collet Closer.

It has an adapter that screws onto the end of the collet closer draw bar. There is a 24” length of 5/8-18 threaded rod that screws into the adapter and has a lock nut. There are also two guides that are also threaded onto the threaded rod. One is positioned just inside of the collet side of the draw tube for centering purposes. The other is located at the end of the threaded rod where the work would contact the stop.

The rod with the collet guide/stop would be adjusted to where the desired location of the part in the collet is.

Due to any extra rod sticking out of the rear end of the collet closer we recommend cutting the thread rod off a few inches outside of the collet closer rear end. There is a possibility that the rod could run into the machine door/window if the table travel to the right is to the maximum.

Whenever the rotary table is being mounted onto the machine table always travel the machine to the X LIMIT and then place the rotary table with the collet closer mounted and with the collet stop a few inches inside of the door/window where that collet stop to door/window contact would take place.