Features:

Completely sealed: Prevents moisture from being trapped inside the housing.
One-way vent: Drives out moisture and avoids lens misting.
Multi-surface reflectors: Increase light output & distance.
PC lens: Impact resistance for an enhanced driving experience in any environment.

 

Fitment:

 

For 1994 Chevrolet Blazer (Not fit sealed beam lights)

For 1994-1999 Chevrolet C1500/C2500/C3500

For 1994-1999 Chevrolet K1500/K2500/K3500

For 1994-1999 Chevrolet C1500/C2500 Suburban

For 1994-1999 Chevrolet K1500/K2500 Suburban

For 1995-1999 Chevrolet Tahoe

 

OEM PART NUMBER: 5977459, 5977460, 5977737, 5977738

 

Package Includes:

 

Pair LH(Left Hand)&RH(Right Hand) Headlight Assembly

 

Installation:

 

1).How to install:

 

1.Undo the screws, clips, or retainer springs that hold the headlight in place.

2.Disconnect the wiring from the assembly.

3.Detach the headlight from the vehicle to replace it with a new one.

4.Fit in the new headlight assembly.

5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.

6.Reconnect the wiring that was unplugged from the assembly.

7.Put back the grille and other components that you removed. Seal them back into place.

8.Test the new assembly.

 

2).How to adjust:

 

Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.

 

1. Find the adjustment screws.Firstly, locate the adjustment screws on your vehicle.

2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.

3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

4.Test your results.