Universal Outboard Motor Flush Muffs With Hoze-lock Connector
For Most Outboard Brands From 20 Hp To 60 Hp with on take grill on the side of gear box

These motor flushers / flush muffs are an essential item to the maintenance of any outboard engine. It is advised to flush your engine after every trip, this applies to both salt and fresh water. These simple steps to flushing your engine will extend the life of you engine and prevent salt clogging the water cooling system and the corroding of internal parts. These are a great value product to prevent a costly engine failure due to sand, grit and salt.

Unlike most flushers there is no need to remove your hose end as these are supplied with a hoze lock connector.

FEATURES
Single flusher with double rubber suction cups.
Simple installation by attaching to hose.


FLUSHING YOUR OUTBOARD
Simply slip the flushers over the lower unit where the water is picked up and attach your hose to the connector.
Start the engine (on tick over) and allow the water to pump through for around 5 minutes.
Be sure to have an even flow of water but not too much pressure as the water will spurt out preventing a thorough flush.
Ensure to keep an eye on your outboard whilst running at all times and keep the hose from getting caught on the prop.
If you are flushing your engine at the end of season it is advised to disconnect your fuel line and allow the engine to burn all the fuel left in the carburetor.


COMPATIBLE WITH THE FOLLOWING OUTBOARD MODELS
    
MAKEMODELYEARS
Evinrude20 hp - 60 hp -
Force20 hp - 60 hp -
Honda20 hp - 60 hp -
Johnson20 hp - 60 hp -
Mariner20 hp - 60 hp -
Mercury20 hp - 60 hp -
OMC20 hp - 60 hp -
Selva20 hp - 60 hp -
Suzuki20 hp - 60 hp -
Tohatsu20 hp - 60 hp -
Yamaha20 hp - 60 hp -