A large right angle gas burner for blacksmiths forge, furnace, foundry. More suitable for fitting into a forge and keeping the rubber tubing out of the way.

It has two air adjusters, the pictures show the three stages of no air, half air and full air intake. A yellow handle gas safe ball valve lets you precisely control heat output.

All inner steel parts welded not glued so it will last.

Burns really well. Works just as well on low psi (1-3 range).

1.5 mm gas tip point.

53 mm burner flare end (outside diameter).

33.27 mm pipe in the middle (outside diameter).

22 cm from flare tip to corner center, 22 cm from corner center to air choke.

8 mm tube connector.

Approx. 100 KBTU output.

All you will need is a high pressure tubing, two jubilee clips and a high pressure regulator for your propane tank.

Many different sizes of burners are also available here alongside complete sets for burners regulators clips and propane tubing:

https://www.ebay.co.uk/str/hammerheadfabrication

Full burner sets (tubing, clips and reg + burner) can be bought here:

https://www.ebay.co.uk/itm/193412603571

Large burners here:

https://www.ebay.co.uk/itm/193766583975

Small burners here:

https://www.ebay.co.uk/itm/193407211073

Small right angle burners:

https://www.ebay.co.uk/itm/193458974271

Medium burners here:
https://www.ebay.co.uk/itm/193412604036
Medium right angle:
https://www.ebay.co.uk/itm/193458990761