HOW TO INSTALL:
Best to install a full wrap in several pieces as needed, such as hood, bumpers, roof, and entire sides. However you seem fit for easiest install.
1) Apply masking tape to area you intend to wrap
2) Use pen/marker to outline edges of panel (example: hood lines)
3) Remove masking tape
4) Place masking tape with template onto decal pattern.
5) Cut around your template with scissors
6) Remove masking tape from cut piece
7) Float piece of decal wrap on water with print facing up for 10-20 seconds
-don't worry the print will not be affected by water, even if left it in water for a long time
-pro tip: warmer water helps make the decal film easier to wrap around, similar to micro sol
8) Wet area where you will install with water or micro set (which helps the decal stick even better)
9) Transfer decal onto car
-technically the printed side should face you, but it can be installed the other way as well, just make sure to lubricate area well first so the decal can slide around.
10) Use a soft brush to push out the bubbles and flatten wrap
11) If needed, you can use micro sol to make the decal more flexible, to wrap around complex surfaces or to wrap around car.
-use micro sol with caution, it will make the decal much more delicate and prone to ripping
12) Allow decal to dry at least 3 hours before clear coating
-No need to clear coat but it's a good idea to protect wrap
-If you want to clear coat, I recommend you:
1. Wait at least 4 hours for decal to fully dry
2. Decontaminate surface from finger oils by dipping car into soapy dish soap water
-you can lightly rub soapy finger along car for a better clean
-if you skip this step, there is a chance the clear coat may react with oils on surface and cause weird problems, especially if you handle the decals/car with oily fingers.
-Always use degreaser dish soap to clean hands before handling decals to avoid contaminating surfaces you will paint
3. Rinse gently with slow flowing ~75F tap water
4. Dry
-do not use a towel or napkin as you'll likely leave behind specs
-you can use a fan, heater, hair dryer, dehydrator, airbrush to speed up drying but using heat is risky as decals may form bubbles
5. Clear coat
-for mirror finish, use 2K gloss clear coat
-allow clear coat to dry naturally
-do not use dehydrator / heater as it can cause decals to bubble if any amount of air was trapped under decals
Note: Micro set and Micro Sol is a liquid solution to help apply waterslide decals. While they aren't always needed, they are very helpful and I highly recommend them for full wrap coverage, especially where wrapping around car is needed or if there are complex surfaces like hood vents. They can be purchased online for about $10 for both bottles and they will last a long time as only a small amount is needed for application, just don't accidentally spill them!
Recommended: Once decals have been installed, wait at least 4 hours before adding Clear coat over entire car for protection.
Avoid handling car or decal with oily fingers as they can cause weird results with clear coat!
--------------------------------------------------------------------------------------------------------------
Be sure to check out my other listings such as:
-Real Riders 1/64 Scale Wheels and Tires
-Headlight and Taillight Decals
-Universal Liveries
-Universal Wraps
-Carbon Fiber Wrap
-Side View Mirrors
-Spacers
Any questions, feel free to ask!
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------
SHIPPING INFO:
U.S. / International Flat rate shipping: Doesn't matter how many decals you buy!
$3.99 First Class Package with tracking
At checkout / cart, click request total so I can fix shipping cost, if you can't find it, I'll refund any extra shipping paid for, no worries!
Buying wheels as well?
U.S. Flat Rate shipping for wheels and decals: $4.99
International Flat Rate shipping for wheels and decals: $9.99-14.99