12V Battery Energy Storage Spot Welder machine Welding Pen PCB Circuit Board NEW
Product Features
  • Lightweight and portable, stable and reliable, wear-resistant, and can provides long service time.
  • Through the MOS tube output, this energy will be concentrated at the end of the welding pen, and it will be heated by a short circuit.
  • Fuse the nickel sheet firmly with the battery.
  • And it is precisely controlled by the single-chip microcomputer program without a trigger switch.
  • Adopt screw fix, more stable, and more reliable.
  • The welding current approx. 90-130A, which is more than enough to welding a common 0.1mm-0.12mm nickel plate.
  • Upgraded to automatically triggered design, do not need to press the button for a long time anymore, completely frees your hands.

    • Note
  • Power supply requirements:
  • It is forbidden to use the power supply of the farad capacitor, and it is forbidden to use the lead-acid battery or lithium battery pack of 60A or above.
  • System voltage: 12V-14.6V (capacity X rate = must be greater than 150A)
  • Current requirements: 150A or more instantaneous output (such as car starter power supply, 3S RC high-power battery pack, 20A lead-acid battery with good performance above 20A)
  • Misunderstanding: Don't think that you can use 3 series 18650 series to supply power. After all, the conventional 18650 only has a 3-5C discharge rate, so each section can only provide
  • 2.5A*3=7.5A load capacity, which is far from 150A unless 20 Parallel connection, 3 series, and 60 sections of 18650 are possible, but it is obviously unrealistic.
  • The battery pack that can start the car can basically meet the power supply requirements of this circuit.
  • The following battery packs can be used as working power:
  • 1. 12V car starter power supply
  • 2. Model 3S high rate battery pack
  • 3. 3 string high rate lithium battery pack
  • 4. Hitachi 40900 3-string battery pack
  • 5. 12V 20A and above lead-acid battery with good performance
  • Switch function: press switch for 1.5 seconds to turn on (green light flash, output low power spot welding pulse every 3 seconds), press switch for 1.5 seconds (blue light flash, output medium power spot welding pulse every 3 seconds), press switch 1.5 Seconds (red light flash, high power spot welding pulse output every 3 seconds) Press the switch for 1.5 seconds to shut down.

    We only accept payment through Paypal.
    Items will go to post within 1-2 business days after payment confirmed.

    If you can't receive the product within 2 months (60 days), please contact with us,we promise to payback 100% of your money.
    We ensure our products work normally before post.If the products is broken before arrival to you,all you should do is taking a photo to show us our broken product.We promise to payback 100% of your money.

    1. We ship to Worldwide.
    2. We only ship to confirmed PAYPAL address; your PAYPAL address must match your Shipping address.
    3. Any non-received items caused by invalid address registered on PayPal are not in our full refund or replacement policy. Shipping fee has including the local handing and packaging fee.
    4. All the items will be shipping within 1-2 working days after receiving the payment, except some holidays.
    5. We will not be responsible for any custom delay or tax, because transit time is highly depended and provided by postal Service.
    6. If you have any problem, please contact us via message, we will reply message within 1-2 working days, please wait for patient.

    DataCaciques