TK64 Trailer Floor Coating is a water-based, plastic coating formulated to withstand abrasion in automotive, industrial and agricultural environments. It offers a textured slip-resistant finish in either black (satin finish) or grey. Apply with included 3/8" foam roller. 2 coats minimum required. Ready to Use. No mixing, shaking or diluting.
- Easy roll on application. Easy water clean-up.
- Water resistant. Non-slip, textured finish.
- Available in black (satin finish) and grey.
- 1 quart covers 12 sq ft. (enough for 2 thick coats)
- 1 gallon covers 48 sq ft. (enough for 2 thick coats)
Use only outdoors or in a well-ventilated area. TK64 should not be exposed to temperatures below 60°F during the application and the curing process. Use proper protective eyewear and clothing.
Excellent adhesion on plywood, treated plywood, oriented strand board (OSB) and bare wood. Ideal for 4x4 tubs, roll bars, bumpers, underbodies, wheel wells, rocker panels, trailer floors and DIY pick-up beds. Mask sure to clean and scuff painted areas, before applying coating to pick-up beds, etc.
- Product cannot ship to locations experiencing temperatures less than 32 degrees.
- Coating must be applied and cured in temperatures of 60 degrees or higher.
- 2 coats minimum required.
- Please note, using less than the required 2 coats minimum will jeopardize the integrity of the coating.
- Excellent adhesion on wood, painted surfaces, clean bare metals, concrete and more.
- Product can only ship to a physical addresses, unable to ship to PO boxes.
New trailer floors will only require a light sweeping out before application.
Used trailer floors require a more thorough cleaning with special attention to oil spots and gasoline spills. For used trailer floors, remove/replace rotted wood and splinters, fill in major cracks/holes with paintable wood putty. Clean floor with waterborne degreaser (i.e. citrus degreaser). Rinse thoroughly with hose/pressure washer and allow for the floor to completely dry. Repeated cleaning of oily spots might be necessary to ensure proper adhesion. A fan will increase air flow and reduce drying time.