Product Description
![]() ![]() ![]()
Front seat cover:
align the bucket cover the seat and slide it down gently,ensure that the designs are lined up correctly
locate the straps in the center of the cover and slip it through the back seat crevice and tighten the traps on the bottom of the seat fit the base part of the cover over seat and fix it by connecting the elastic loops underneath the seat with the snaps Rear bench cover/backrest cover:
Remove the rear bench from your car and lay it on the ground, fit the cover over seat and fasten the elastic bands with hooks. Then, reinsert it.
Rear headrest cover:
Fit the headrest cover over rear bench headrest, cut some tiny holes to fit the attachable headrest after you are completely ensure that the backrest cover is aligned and fitted to your satisfaction.
TIPS: Enough clips can secure them to the car seat. But if you want a best-looking fit, they do require a little bit of time and effort.
6 small holes you have to make for the back headrests, 2 small holes at where the belt buckles are in order to pull the belt buckles out
To remove armrest: the screw is located at the end of the armrest. Remove the round cap and undo the screw inside to take out the armrest. After you have installed the seat covers, redo the screw and put back the armrest. A good set of pliers maybe help you create a ‘perfect’ fit. you can really jam the clips into the existing fabric.so you can get in and out of the car hastily and not worry a bit that the covers are going to slide around. |