Digital Pressure Gauge Hydraulic Display Battery Powered 25MPa 3V BSP1/4 Base Entry
  • Condition: 100% new
  • Housing Color: Silver
  • Material: Stainless Steel
  • Accuracy: 1%
  • Long-term Stability: 0.5%FS/Year
  • Size: As picture shows
  • Outer Diameter: approx. 6.5cm(2.56inch)
  • Thread Diameter: approx. 1.2cm(0.47inch)
  • Pressure Range: 250BAR/0-25MPa/3600PSI
  • Working Temperature: -20 to +50 Celsius
  • Measurement Medium: Gas, Water, Oil
  • Function: On and off, Backlight, Zero clearing, Unit changing
  • Power: 3V
  • Battery: 2*3A Batteries(not including)
  • Screen: 4-Digit LCD Screen
  • Back-light: White
  • Date retention: EEPROM
  • Item included: 1 x Digital Pressure Gauge with Manual (Battery is not included)
  • Suitable for: Measure gas, liquid, oil and non-corrosive mediums of stainless steel

  • This Is Aftermarket Replacement Item But Not Genuine

  • Note:

    1) All dimensions are measured by hand, there may be small deviations.

    2) Color may vary slightly due to the color setting of each individual monitor.

Product Dimension:

Feature:

1) According to the original factory specifications.

2) Stable characteristics, high reliability.

3) This gauge is a economical digital pressure gauge. It has a high-precision sensor and display the pressure accurately in real time, such as zero clearing, backlight, on/off button, units, low voltage alarm.And it is convenient to install and easy to operate.

4) It applies to these fields: pressure container, automation equipment, matching with laboratory equipment. Can be used to measure gas, liquid, oil and non-corrosive mediums of stainless steel.

5) Equipped with a large size LCD.

Function:

1. On/off. Short press the power button to turn on and long press the power button to turn off.

2. Unit switching. Cyclic switching unit by pressing unit switching key.

3. Zero Clearing Function. Without pressure, press zero button for 4 seconds to clear the zero error.

4. Back-light function. Short press the back-light button and turn on the back-light for 20 seconds. Long press the back-light for 3 seconds, and the back-light will

remain bright until the back-light key is pressed again.

5. Adjusting the filter constant. Press On/off key + back-light key at the same time, it will display r-03',indicating that the current filter constant is 03. The number can be set by pressing key button, and the range can be modified from 01 to 10. After setting up, press the back-light key to exit.

6. Note: The smaller the filter constant, the faster the digital change, the slower and more stable the digital change.

DataCaciques