Classic Wooden Launch. 21 Feet.. “Elender of Salcombe”Here is a rare chance to finish a classic wood launch to your own specifications and design touches.Elender is being dry stored about 2 miles from the Salcombe Estuary and can be viewed/inspected by prior arrangement.Do not miss thss chance to own and love a Classic Wood Launch with a lovely heritage. Details are as follows. “Elender of Salcombe” - £8,900 ono.Work done so far• Removed old floorboards • Removed rotten capping • Removed rotten fore deck • Removed old risers• Winterised Engine• Stripped Hull exterior of varnish• Stripped Hull interior of old paint and cleaned• Faired Hull exterior• Primed Exterior of Hull with Primocon and Pre-Kote• Primed Interior of Hull with Yacht Primer and Pre-Kote • Painted Bilge with Danboline• Made and fit risers• Removed old sternpost• Made new Oak sternpost - not fitted• Removed old thwarts• Cut new thwarts - not fitted• Measured up for new floorboardsWork to do• Replace capping• Potentially re-fasten plank ends• Fit sternpost• Fit thwarts• Cut and fit ply fore deck with bulkhead and hatch• Lay decking on fore deck• Cut and fit floorboards• 2 minor plank repairs• Seal interior plank ends near sternpost and stem with hot tar • Service and paint engine• Spruce up engine box• Paint• Replace brass band on stern• Varnish• Sand anti-foul• Re-apply anti-foul• Minor service of trailerIncluded• Remaining paint / varnish / anti-foul• Remaining Silicone Bronze screws• Squared and Planed 3/4” Siberian larch (enough for floorboards and cut to length) • 6x Sapele knees for thwarts• Planed 3/4” Larch for capping• Mahogany thwarts• Tar for melting and sealing• Rudder• Tiller• Trailer***** ADDITIONAL PHOTOS AVAILABLE UPON REQUEST