50 + 50 Doppel Elko 500 V Elektrolyt KondensatorHier sind
zwei Elektrolytkondensatoren mit 2x 50 µF und 500 V in einem Gehäuse
untergebracht und der Minuspol beider Kondensatoren wurde zusammen auf
einen Anschluss gelegt. Durch die hohe Spannungsfestigkeit ist er
geschaffen für Röhrenverstärker, wo immer hohe Spannungen anliegen. Die
Bauform ist identisch mit den Kondensatoren der alten Marshall, Hiwatt
und Orange Modelle, so dass die Optik erhalten bleibt wenn man den Amp
restaurieren will und die Kondensatoren ersetzen muss. Die
Endstufenröhren produzieren viel Wärme. Das führt zum Austrocknen der
Kondensatoren. Man sollte die Kondensatoren also rechtzeitig ersetzen,
denn sonst kann ein defekter Kondensator noch viel größere Defekte in
einem Röhrenverstärker verursachen, so dass die Reparatur noch viel
teurer wird oder sich gar nicht mehr lohnt. Doppel- Elko. Ideal für die Restauration alter Verstärkerlegenden. - Bauform radial Becher, stehend
- Kapazität 50 + 50 µF
- Spannung 500 V
- Temperatur 85 °C
- Maße 85 x 35mm inkl. Anschlüsse
- Montage durch Ringschelle (nicht im Lieferumfang enthalten)
|
Sie erhalten eine Rechnung inkl. MwST. von MyTubeAmp.de
|
50 + 50 µF electrolytic capacitor radial 2x 50 mF cap 500 V
Here
two electrolytic capacitors with 2x 50 ΜF and 500 V are housed in one
housing and the negative pole of both capacitors was placed together on
one connection. Due to the high voltage resistance, it is designed for
tube amplifiers, where high voltages always concern. The design is
identical to the capacitors of the old Marshall, Hiwatt and Orange
models, so that the optics will be preserved if you want to restore the
amp.
The
power amplifier tubes produce a lot of heat. This leads to the drying
out of the capacitors. You should replace the capacitors in good time,
because otherwise a defective capacitor can cause much larger defects in
a tube amplifier, so that the repair will be much more expensive or
even not worth it any more.
Double electrolytic cap. Ideal for restoration of old amplifier legends
- Design can radial
- Capacity 50 + 50 µF
- Voltage 500 Volt
- Temperature 85 °C
- Dimensions 90 x 35 mm including the connections
- Mounting by ring clamp (not included)
You will get an invoice from MyTubeAmp.de