Specifications
[1]: 50/100led solar copper wire string lights
1. Solar panel: 2V 150MA
2. Light source; Super bright led
3. Ni-mh batteries: AA size. 600mah, 1 PCS
4.Charging time: 6-8h
5.Working time: Steady on mode 8-12h; Flash mode 10-15h
6.Modes of"ON"OFF"and"Flash
7.Working tmperature; -20C +60C
[2]:200 led solar copper wire string lights
1.Solar panel: 2V 250ma
2.Light source: Super bright led
3.Ni-mh batteries: AA size, 1200mah.1 PCS
4.Charging timne: 6-8h
5.Working time: Steady on mode 8 -12h ; Flash mode 10-15h
6.Modes of"ON", "OFF"and "Flash
7.Working temperature:-20C~ +60'C
Bulb
The lights bulb is constructed with non-replaceable.
DO NOT attempt to replace any bulb , Shelf life of led bulb is over 20, 000 hours.
Warning
1. This product is not a toy. Please keep away from childrenunder 3 years old.
2. This product contains small parts which may cause choking hazard ifdetached.
3. Please do not allow children to play with the anchor spike since the end point of anchor spike is sharp.
4. Keep away from fire or other sources of heat.
5. Avoid the batteries and wiring dip into water.
6. Some condensate may form inside the unit or solar panel incoldcondition. This is normal and can be ignored.
General Introduction
The solar light consist a solar cel, a rechargeable battery andled lights. And the three parts are preassembled. Light from the sun charges the batery during the day time and the energy stored in the batteres powers the lights at night.The lights ontime maybevary, depending on how much power received fromlightduring day time.
1. The light s designed for outdoor use only in an open kxationforrecerving direct sun light.
2. Please avoid purtmg the unit under shadows from bulnestrees and walls.
3. The unit is designed to illuminate im dark condit ions and maynot operate if other source of strong lights reflects on the pane.
4. Choose a soft ground to push the spike in to locate the light.
User Instruction
1. Removethe package andmake sureeverything is in a goodcondition .
2. Assemble the solar panel to the cradle on the anchor spike.
3. Tum the ON/Off switch at the bottom to"ON" position.
4. flash modes with automatic switch.
5. Put the light at the right and safe place.
