MG ZT & Rover 75 FWD Pair Front Brake Pipes Kit SGB003500 SGB114081

This kit includes:

Left Front brake pipe     SGB003500

Right Front brake pipe   SGB114081

2x plastic pipe clips        EDP7037

2x pipe to hose clips      SGK100670

Wiring loom cable tie

Please read all of the text here and in all 12 photos for further information and fitting tips.

Replacement front brake pipes for all MG ZT and Rover 75 FWD (Front Wheel Drive) models, LHD & RHD (left hand drive and right hand drive) 1998 - 2005 with and without Traction control.

Please note the photo sequence within this listing shows copper / nickel brake pipe sections for illustration purposes. This listing IS for Green original style pipes.

Both sections runs directly from the ABS modulator to the front brake hoses which can be prone to corrosion. The replacement sections come with the special clips for the brake hose ferrule which is also prone to corrosion and the plastic clips to the chassis rails.

They have been fabricated in house with original style MG Rover green brake pipe and unions, when fitted will give the correct look of the original as would be factory fitted.

The brake pipe sections have been fabricated as per the original MG Rover part numbers SGB003500 (LH) and SGB114081 (RH), both part numbers are no longer available however please note;

Having worked on these cars from new, when these pipes were available as new original parts SGB003500 (LH) was supplied as a pre formed ready to fit pipe. However, SGB114081 (RH) was supplied as a correct length etc, but it was a straight pipe cable tied to a long strip of thin plywood which needed forming into shape.

IMPORTANT: 

The LH brake pipe can be fitted as normal and is pre formed in the factory shape.

The RH brake pipe has the final bend left straight- this is the only way to fit it from the engine compartment side with the engine and transmission still in place! The installer must make the final bend in the wheel arch area close to the suspension strut down to the brake hose.

I can supply the RH brake pipe with this final bend in place, but it would be on the understanding that it is for a car undergoing a complete restoration without the power unit fitted.