New 8mm/16mm Projector
Ceramic Lamp Connector.
Will Fit The Following Double Pin Type Lamps (pin gap 6.35mm).
12volt/100watt Reflector Lamp (A1/231) Majority of 8mm Projectors.
12volt/100watt Capsule Lamp (A1/215) Eumig Mark S & others.
15volt/150watt Reflector Lamp (A1/232) Elmo ST1200, Sankyo 800 Stereo & others.
24volt/250watt Capsule Lamp (A1/223) Rank Aldis 16mm & others.
24volt/200watt Reflector Lamp (A1/252) Earlier Elf 16mm Projectors.
24volt/250watt Reflector Lamp (A1/259) Elf and Some Bell & Howell 16mm Projectors
May also be used if you are wanting to convert an old projector to a modern lamp type
Does your projector lamp flicker on and off occasionally?
Or perhaps you've fitted a new lamp that still refuses to light?
Usually this is down to corroded contacts within the original lampholder caused by
high current (8 amps for a 12v 100w lamp and around 10.5 amps for a 24v 250w lamp).
This in turn will shorten the life of a new lamp significantly, which is definitely not cost effective.
These new porcelain holders have a better sprung contact system inside that permits a more stable
current transfer to the lamp. The cables are protected by heat resistant rubber and as a final
protection, encased in a further heat/flame retardant shroud.
Far superior in quality to the cheap flimsy lamp connectors offered by
other sellers which were intended for low wattage domestic lighting
such as found under kitchen cabinets etc.
This item needs to be soldered to the original wiring to your existing lamp.
Alternatively you can use ceramic terminal blocks.
Please Note:
I will not sell to you if you are using any kind of third
party forwarding company. There are too many
issues with mail going missing and
it then becomes a three way communications problem.
I will only sell direct to
your own personal address. If you do happen to purchase something
from me that
is destined for a forwarding company, then I shall cancel the sale and
mark the
reason as “there was an issue with the buyers address.”