K27-SW-GEAR (Not for EASY module kits) - Shift Rod Type A Required

This Quickshifter is designed as an add on module (not stand alone) and must be installed in conjunction with a Rapid Bike Evo or Racing fuelling kit.

The Load sensor cell plugs into the Rapid Bike wiring harness and manages a fuelling/power cut to allow an up-shift into a higher gear without using the clutch or closing the throttle. It is a universal item and works either by push or pull.

Note: Not suitable for use with the Rapid Bike Easy fuelling kit.

SHIFT ASSIST

OPTIONAL EVO - RACING

Latest Rapid Bike SHIFT ASSIST represents a big step forward in terms of quick-shifting solution thanks to a further technological development to perform up-shifting (traditional mode) as well as down-shifting operations (the so-called ‘blipper’, available only for bike models equipped with ‘ride by wire’). A new device reaching unmatched technical standards designed to deliver outstanding performance to race track enthusiasts and further improve riding experience.

New shifting device exchanging information with EVO and RACING add-on modules via CAN-bus allows to perform auto-calibration of shifting kill-time in relation to the pressure applied in both directions, upper and lower gear, while matching the engine peculiar configuration. A greater bike’s handlebar control and lower mechanical stress, granted by the unique ‘self-learning’ process, improve considerably driving safety.

Full compatibility with YouTune to manage pressure level applied for activating shifting operations. Another additional feature to be managed via YouTune is the modulation of engine response sensitivity when opening throttle control.