Ladies and gentlemen! Your attention is invited  set of five carbide tools.

         Carbide cutter for working on stone, ceramic tile rubber, leather,
                              artificial  leather, vinyl fabric, rubber, etc. 

                                                          Cutter 1

                                        Total length - 154 mm - 6.06″
                                          Plate width -    10 mm - 0,39'
                                          Working part - 18 mm - 0,71"
                                          Rod diameter -  8 mm - 0,31"



                                                            Cutter 2

                                           Total length - 150 mm - 5,91"
                                           Plate width -      8 mm - 0,31"
                                            Working part - 13 mm - 0,51"
                                            Rod diameter -  6 mm - 0,24"


            This carbide pen is used for drawing lines (dash lines, markings)
                             on the surface using a ruler or a template.
         The hard alloy marking pen is designed for marking on a hard surface
                          (metal, stone, tile, glass) during various works.

                                                            Pen 1
                                                Length: 150 mm - 5,9"
                                               Diameter: 7 mm  - 0,27"
                                            Rod diameter: 3.4 mm - 0,13"
                                              Working part: 8 mm  - 0,31"

                                                                                      
                                                              Pen 2
                                                  Length: 145 mm - 5,7"
                                                 Diameter: 6 mm  - 0,23"
                                            Rod diameter: 3.35 mm - 0,13"
                                                Working part: 8 mm - 0,31"



                              Carbide center punch locksmith's marking tool,
            used to make holes on the marked material for the initial installation
                                                  of the tool, for example,
            a drill bit during drilling or a compass leg when marking
                                             arcs and surrounding areas.
 
                                                      Length: 125 mm - 4,9"
                                                     Diameter: 10 mm - 0,39"
                                                  Rod diameter: 5.5 mm - 0,21"
                                                    Working part: 9 mm - 0,35"