|
About install kit: This is a RGB modding install kit for SEGA/JVC WONDERMEGA RG-M1. Remove off an original RF out and then put a this DIN 9pin out that has protected with 3D printed holder. Pull needed signals from back side of the console board using a long FFC cable. Replaced DIN 9pin jack has compatible with SegaGenesis2, SegaMegadrive2 and 32X. Will introduce how to install on YouTube video. How to install You can connect your 32X unit through a 32X linking cable after completed install this kit. But need to simple cutting work for mounting physically. Will introduce how to add 32X unit on YouTube video. How to add on Feature: Replace an original RF out to DIN 9pin out. DIN 9pin out has combined with 3D printed holder so absolute fixation. Fix the 3D printed holder using a bolt. Clean installation that is never used any sticky material in the whole process. Connect the SegaGenesis2 Scart RGB cable directly without additional any modding. Disclaimer: This installation work requires to soldering tools and skill for it. If you aren't able to do it on yourself from beginning to end, please don't buy this kit. I'm not going to any advise and any assistance to your installing work. I refuse to any monetary compensation even if you makes break a console caused in your soldering fails. And then I refuse providing replacement parts even if you lost the something parts in your manegement mistakes and physical damaged. |
|
Kit parts detailes:
--- DIN 9pin out that has protected by 3D printed holder. --- SOPIC mounting board. --- Long FFC cable. --- Bolt and nut. Not only enable the Scart RGB cable and 32X link cable but also accept the DIN 9pin composite video cable in compatible with SegaGenesis2/Megadrive2. I will accept combine shipping with other selling kits. Shipping charge is US$18 only(except some countries). |