Protocols
Logical interface ex factory Operates as
Ex factory
Input voltage range V Power consumption W Connectors

Hardware interfaces

Adjustment time sec (full range)

Adjustment cycles Temperature range °C Protection class
Lightning protection

Housing material

Weight g lb

Packing size mm (H x W x D) inches

Dimensions mm (H x W x D) inches

Please note:

•Daisy Chain feasibility •Pre-configured

compliant to 3GPP/AISG 2.0

3GPP/AISG 2.0

Single RETs or Multi RET

Single RETs

10 ... 30 (pin 6)

Typically < 1; < 10 (motor activated)

2 x 8 pin connector according to IEC 60130-9; according to AISG-C 485 Daisy chain in: male; Daisy chain out: female

RS 485A/B (pin 5, pin 3);
power supply (pin 6); DC return (pin 7); according to AISG / 3GPP

40
(typically, depending on antenna type)

> 50,000 –40 ... +60
IP 24 (installed)

AISG interface (each pin)
2.5 kA (10/350 μs)
8 kA (8/20 μs) according to IEC 61000-4-5

Profile: Aluminum anodized; cover: Aluminum die cast coated

350 0.77

245 x 93 x 102 9.6 x 3.6 x 4

142 x 71 x 51 5.6 x 2.8 x 2

If the Primary which controls the FlexRET system does not support the default ex-factory interface set- ting, then the FlexRET must be switched to the appropriate standard of the Primary before installation. Please contact Kathrein for further information.

If the FlexRET of an antenna has to be replaced, the FlexRET gets the information stored in the antenna after power on automatically. It is not necessary to configure the FlexRET manually.

Standards:

EU-RED:

Certification: Scope of supply: Optional:

Please note:

EN 60950-1 (Safety)
EN 60950-22 (Safety – Equipment installed outdoor) EN 55022 (Emission)
EN 55024 (Immunity)
ETS 300019-1-4 (Environmental)
UL 60950-1; 1st edition

Hereby, KATHREIN SE declares that the radio equipment type 86010153V01 is in com- pliance w+ith Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.kathrein.com

CE, FCC FlexRET