Gimbal Bearing Puller & Alignment Tool For Mercruiser Alpha, Bravo, OMC & Volvo
Gimbal Bearing Installer Bearing Puller:
  • Fits for Mercruiser Alpha, Alpha 1, MR, bravo's, OMC cobra's and Volvo. (note: A hole needs to be drilled in the alignment tool to install the universal bearing driver.)
Hinge Pin Tool 18-9861:
  • Fit for all marine push plate tail drives: Alpha One, Alpha One Gen II, BRAVO I, II & III along with MC-1, R & MR. Replaces 91-78310, 18-9861 & 90200.
Function:
  • ①Gimbal Bearing Installer Bearing Puller Used to easily remove/install Gimbal bearings and alignment tools for engine alignment.
  • ②Hinge Pin Tool 18-9861 Used for Removal and installation of Hinge Pin from Drives. Specifically used on hinge pin bolts and separate the housing from the gimbal ring.
Features:
  • Gimbal Bearing Installer Bearing Puller Tool Set includes eye bolts can hang alignment tools. The blind hole puller is locked in the inner ring of the bearing. The tool makes it easy to pull the bearing, just use a wrench to turn the end of the tool to pull the bearing. Volvo's sliding hammer jaws no longer have the trouble of being stuck and broken.
High Quality:
  • This set made of high standard carbon steel which can withstand corrosion, rust and impact, with nice black Oxide finish, ensures an unparalleled long lifespan.

Gimbal Bearing Replacement

  1. Insert the Rod into the Gimbal Bearing.
  2. Once It's in There, We Can Place the Plate.
  3. Once You Are Getting Close to Being Snug, Put the Center Rod in till It's Tight.
  4. Use a Large Adjustable Wrench and Just Start Turning This Around and Around. and Then It Will Start Going Easy. Remove the Tool. the Gimbal Bearing Is off.

Gimbal Bearing Installation

  1. Once You Get It Started Just Take Your Tool out and Make Sure It Is Going and Relatively Straight If It’s Not It’s Gonna Be a Lot Harder.
  2. Installing a New Bearing Requires a Quality Special Tool. It Is Very Important That the Replacement Bearing Is Driven All the Way in.1

Engine Alignment

Tip: If the Engine Was so Misaligned That You Are Unable to Insert the Alignment Tool, Use a One Inch Diameter Pipe to Help Determine Which Direction to Move Your Engine.

 

PushAuction