Made-to-order 3D Printed Honda Civic Dash Pocket Phone Mount for 8th Gen Civic (2006-2011).

Printed in temperature resistant PETG filament, this mount is very sturdy and won't melt or warp from the high summer temperatures.

This phone stand is designed to mount below the rubber insert on the inside of the dash pocket (located under the climate controls) while still giving you access to the factory dash pocket as well as the larger pocket located directly below the mount. This mount is compatible with almost all current smart phones (phone case recommended). If your phone fits between the 12volt cigarette outlet and the right side of the pocket wall, this should work for you. I have an iPhone 12 Pro Max in an Otterbox Defender case and it fits perfectly.

**Phone shown in photos is an iPhone 6 Plus in an Otterbox Defender case.

Easy Installation Instructions:

1. Remove the original rubber insert inside the dash pocket by lifting up vertically.

2. Line up and insert the mount into the dash pocket so it sits flush.

3. Using the supplied screws, create the new mount holes by screwing the mount into the inside of the pocket (the screw holes will be hidden under the original rubber insert if you ever remove the mount in the future). You can also use double sided sticky tape instead of the screws if you prefer.  Reattach the original rubber insert by lining up the nipple to the hole in the mount.

4. Once complete, the pocket should look almost the same as it did before and you will still have full access to use it as you did prior.

These are made-to-order so please allow some time for production. If you have any questions, please ask and I will respond promptly.

*Additional items shown in photos are not included.