The NIS SCOM Cable is intended for Nissan and Infiniti cars build between years 2001 and 2008. Majority of these cars are equipped with a 16 pin OBDII connecter and use Consult II protocol over K line (DDL2). The connector is usually located near the fuse box.

The NIS SCOM Cable supports factory model. Aftermarket are not compatible with this cable.

Note: Some vehicles may use K-line for diagnostics of engine but still use DDL1 line for diagnostics of other control modules. This software does not support diagnostics over the DDL1 line.

ITCARDIAG NIS SCOM Diagnostic Tool for Nissan and Infiniti Highlights:

1. Self Diagnostics: reads and resets error codes.

2.Active Test: The Active Test function can be used to temporarily modify some of the engine parameters. They return to their original values when a function is stopped, PC disconnected, or engine restarted.

3.Work Support:

Clear Self Learn

Idle Air Volume Learn – is an operation to o learn the idle air volume that keeps each engine idle speed within the specific range.

Program Immobiliser Key – registers transponder keys with the Immobiliser

Note: The immobiliser security PIN CODE needs to be known.

Steering Angle Sensor Reset – After removing/installing or replacing ABS control unit, steering angle sensor, steering components, suspension components, tyres, or after adjusting wheel alignment, make sure to adjust neutral position of steering angle sensor before running vehicle.

4.Cylinder Power Test, Speed Test

5.Log Analyser

6.Data Replay

7.Fuel System Status,Monitor Status

8.Wideband O2 sensor

language: English

Operating system: win7, win10