This was a variation listing. we sell fuel sender Only or Fuel Gauge/Water Level Gauge Only. The main photos were just for your reference.
Fuel sensor
1.For car,truck,bus and marine field widely used in fuel,water,kerosene and chemical tanks,sensors can be used with all gauge brands that have compatible ohms.
2.Steady output signal simple and stronge structure , advanced corrosion resistance
Long using life, anti-vibration,anti-explosion fuel sensor
High quality fuel level sender
Economical level sensing solution, long service lifespan.
3.Without limitation of environment.
recommends that a minimum 1" clearance must be maintained between the tank bottom and the float retaining collar
Length: 150mm,160mm,165mm,200mm,225mm,250mm,300mm,350mm,375mm,400mm
(If you need customization or other sizes, please contact us)
Mounting methods:Standard SAE 5 hole pattern
Output signal: Standard American 0-90 ohms Empty-Full
Protection rank: IP67
Resolution range: 21 mm
Connection:
Brown--Signal Input
Blue--Ground(-)
Fuel gauge
Fit For:Car Truck Motorcycle ATV UTV Marine Boat
Signal:0-90Ohms
Blacklight Color:Red
Bezel Materials: Stainless Steel
Indicating Range:Empty(0)--Full(90)
Operating Voltage:9-32VDC
Operating Current:≤60mA
Operating Temperature:-30~+75 ℃
Storage Temperature:-40~+85 ℃
Install Diameter: 52mm(2-1/16'')
Grade Of Protection :IP67
Package Method :Neutral box
Installation instructions:
1.Opening a hole in the panel (your cabin board and dashboard) with a diameter of 52mm,Insert meter into the hole,The panel corresponding to the instrument panel is marked with a convex table,and open a small notch in this location,To ensure that there is at least 70mm of the instrument panel at the back of the instrument.
2.After the instrument is mounted in the panel,Screw down with a fixed ring.
3.Connect signal Connect the wire,the instrument housing is directly connected to the 9~32V power supply.
4.Insert wire harness,Firmly locked in the table.
If you need other signals fuel meter see:
Connection:
Red--+9-32VDC
Black--Signal Input
Orange--Backlight(+)
Blue--Ground(-)