one Main features:
Compact size, complete functions, easy to operate, easy to carry. It can be powered by an adapter or a single lithium battery. Together with oscilloscope, can be used for electronic circuit testing and debugging, audio amplifier frequency characteristics and pulse response testing and measurement. DDS is also very suitable for oscilloscope scanning time factor calibration because of its good accuracy and frequency stability. Square wave output is suitable for oscilloscope attenuator and probe pulse characteristic adjustment.
Ii. Main Technical Indicators:
1. Frequency range: sinusoidal wave 1HZ-500khz (the frequency with flat output amplitude reaches 200khz, and the output amplitude will decrease with the further increase of frequency), other waveforms 1HZ-20khz (but the upper limit of adjustable frequency is not limited, if the distortion and sloshing requirements are not high, the frequency can be further increased).
2. Resolution: 1Hz.
3. Output waveform: sine wave, square wave, triangle wave, forward sawtooth wave, reverse sawtooth wave.
4. Sine wave distortion: <1% below 1kHz, <0.5% above 1kHz.
5. Output amplitude: maximum ±10V(P-P).
6. Output impedance: 50 ohm.
Dc offset: maximum ±10V, with shutdown function.
8. Can open and close the filter, can be well adapted to the sine and pulse waveform output.
8. Power supply: DC3.5-10V DC5V is recommended for the adapter and 3.7V lithium battery is recommended for battery power.
9. Overall size: 125x80x32.
Package Content:
1 X Signal Generator
Notes:
1.Please compare the detail sizes with yours before you buy.
2.Colors may be slightly different depending on computer and monitor settings.
3.Please allow 1-3cm differs due to manual measurement (All measurement in cm and please note 1cm=0.39inch, 1inch=2.54cm)
