Material: Diamond

Diameter: 4mm , 6mm , 8mm , 10mm , 12mm , 14mm , 15mm, 16mm,18mm , 20mm

Grit :Fine (600#)

Shank Diameter: 3mm , 6mm 

Total Length: 65mm 

Scope of application. Can be mounted on the electric grinder, engraving machine, pneumatic engraving pen to use. The diamond grinding head is made of polygonal diamond plating, mainly used for grinding processing, mold processing and repair, stone carving, carving flowers, cutting lines, grinding hollow, jade carving, glass carving, cleaning casting, forging, welding parts of the burrs, burrs, weld seams. Tooth grinding processing. All kinds of mechanical parts chamfering and groove processing to clean up the pipeline, finishing mechanical parts of the bore and surface.

✿  Features: 

Electroplated diamond grinding disc is the best correction tool for processing various molds, glass instruments, and jade carvings.

It can be installed on hanging grinders, electric grinders, engraving machines, and motors.

6mm mandrel handle, please choose the one you need according to your rotating motor.

Mainly used for grinding, mold processing and repairing, stone carving, carving, wire cutting, polishing, carving, jade carving, glass carving, cleaning casting, forging, welding parts, burrs, welding seams. molar. Chamfering and groove processing of various mechanical parts. Pipe cleaning, hole and surface finishing machine parts.

When using diamond burrs, use water as a coolant.

✿ Warm tips: When using diamond tools, please pay attention to the following matters:

1. When you newly install the tool, you must try to see if the tool jumps, if it jumps, you can't work directly, you have to adjust it to not jump before you can use it. Otherwise, the tool will wear out quickly, and the carving out is not very smooth. Adjustment method: use a small wrench to change the chuck to gently knock the high-speed rotation of the tool handle until the tool is smooth. Electronic machine is strictly prohibited to knock, the adjustment method is to loosen the collet, turn the tool at an angle or extend and indent a little.
 
2. Be sure to put water cooling (similar to the hospital drip drip device), such as dry drilling, the tool head of the diamond due to overheating will be graphitized, and thus quickly worn out scrapped.

3. When drilling, avoid shaking as much as possible, because shaking will cause local damage to the tool and accelerate the damage of the whole tool.

4. Rotate the speed as high as possible. The general requirement is a line speed of not less than 10-20 meters per second.

5. Light pressure to feed, diamond tools rely on grinding to process the workpiece, excessive force, grinding powder is not easy to exclude, the tool is also easy to damage.