Introduction:
*This is a HF band QRP SSB / CW transceiver. It is very small and easy to carry outdoors. It uses a 0.96 "OLED LCD screen for easy reading.
*Built in speaker, support to connect to PC, use FT8, jt65, FT4 and other digital modes, support CW mode, software control, and support CW automatic decoding.
feature:
- 4-band coverage 10/15/20/40M 4 Band (modified based on the source program and different from the source program)
- Excellent PCB design and excellent circuit performance.
- Using 13.8V power supply, the power can be up to 3-5w in three bands, and the SOT-223 packaging pad required for upgrading is reserved.
- High launch efficiency, with 40m / 20m efficiency higher than 80% and 15m efficiency higher than 60%. (Note: transmission is prohibited in non 40m / 20m / 15m / 10m band and can only be used for reception)
- Ultra small volume and weight: 160 * 50 * 20MM (excluding protruding parts), body weight 340g, very suitable for mountaineering.
- Multiple interface - cat, MIC / key, audio (headset supporting adaptation).
- 100V or 250V cog / NPO capacitors are used for LPF.
- Use magnetic holding relay.
- Use ne5532 operational ALF chip.
- Built in high-quality speakers.
- BNC antenna interface.
Specification:
Frequency Range:
Receiving: 0.5MHz ~ 30MHz (theoretically it can reach the limit of SI5351)
Transmission: 1.8~30MHz
Working mode: CW, AM, SSB
Minimum step: 10Hz
Antenna Impedance: 50Ω
Operating temperature range: 0℃~+50℃
Power supply voltage: 10.5 ~ 16V DC, the negative pole is grounded.
Current consumption:
Receive: 100mA@Max
Launch: 1A@Max
Body size: 50 x 20 x 180mm (W x H x L) (excluding protrusions)
Weight: about 340g (main unit only)
RF output power: 0.1-5W (SSB/CW)
0.1-5W(AM carrier) @13.8VDC
Battery capacity:built-in1100mAh rechargeable battery(The reception mode can be used for about 10 hours)
MORE INFORMATION:
PHONE: 1 MIC 2 GND 3 AUDIO 4 AUDIO
MIC/KEY:
MIC mode: 1 GND 2 PTT OUT 3 MIC 4 PTT
KEY mode: 1 GND 2 PTT OUT 3 LEFT KEY 4 RIGHT KEY(Swap order is available via menu 2.7 Keyer swap)
TTL:1 GND 2 RXD(TO USB-TTL CABLE TX)3 TXD (TO USB-TTL CABLE RX) 4 DTR (TO USB-TTL CABLE DTR)
DC IN: Negative outside, positive inside
Package includes:
1 * Pocket Radio
1 set of other accessories as the picture shows