8pcs Ignition Coils +16pcs Iridium Spark Plugs+8pcs Spark Plug Wires For Dodge Ram 1500 2500 3500 5.7L V8 UF378
Feature:
Connector: 2 Pins
Connector Gender: Female
Terminal Gender: Male
Terminal Type: Blade
Voltage: 12V
Thread Length(mm): 14mm
Spark Plug Type: Soft Plug
Specifications
Brand New Ignition Coil
Built to strict quality control standards.
Ready to use, Direct Replacement.
100% Compatible with OEM Parts, meets Original Equipment Manufacturer (OEM) Standards
100% pure copper windings in bobbins improve durability ,thermoplastic housing withstands heat stress for enhanced durability
Silicone rubber boot withstands extreme heat to ensure superior insulation
Spark Plugs are using High-Performance Iridium metal, Much better than Nickel and Platinum
It's suggested that ignition coil and spark plug be replaced in a sychronized manner to lower the likelihood of common ignition system dysfunctions such as failure to start, engine vibration, misfiring, inadequate power, spark plug fouling and poor fuel economy
Warranty: 1 Year
Package including: 8pcs Ignition Coils +16pcs Iridium Spark Plugs+8pcs Spark Plug Wires
If you have any questions, please contact us first and we will solve it for you. Thank you for your kindness!
NOTE:
- Installation Manual Is NOT Included.
- Professional Installation Is Highly Recommended.
- Please check the part number on your old part housing before purchase.
- please confirm the item if it matches your car before you purchase.
- We only sell BRAND NEW parts, unless otherwise stated.
Replace for :
Ignition Coil: UF378, UF505,GN10372
Iridium Spark Plug: 6987
Fit for:
2005 Chrysler 300 5.7L V8
2004-2005 Dodge Durango 5.7L V8
2005 Jeep Grand Cherokee 5.7L V8
2005 Dodge Magnum 5.7L V8
2003-2005 Dodge Ram 1500 5.7L V8
2003-2005 Dodge Ram 2500 5.7L V8
2003-2005 Dodge Ram 3500 5.7L V8
How to Change Ignition Coils and Spark Plugs?
This product recommends professional installation.
1. Disconnect the old ignition coil and spark plugs
2. Disconnect your battery’s negative terminal
3. Locate the ignition coil and spark plugs to be replaced.
4. Release the clip on the plug running into the side of coil.
5. Use a wrench to unscrew the bolts holding the original coil in place
6. Extract original ignition coil and spark plugs from the engine bay
7. Swapping in the new ignition coil and spark plugs
8. Prior to installation, compare the new coil to the old one
9. Orient the new coil in the same direction
10. Insert the bolts to hold the coil in place
11. Activate the New ignition coil and spark plugs
12. Connect the plug into the side coil
13. Plug in ignition cables according to the order written on them.
14. Reconnect the battery
15. Start the vehicle to test the new ignition coil and spark plugs
Note:
1. In preparation for the replacement, the vehicle should be turned off and cooled for a certain period of time before starting the replacement.
2. Pay attention to the cleanliness of the entire operation, must wipe the ignition coil around the dust and oil, if into the combustion chamber, will have serious adverse effects, try to wear gloves to operate.