Description:

1. The machine is equipped with high-precision Emery wheel. When grinding various scissors and other tools, it can maintain the characteristics of low temperature in a short time, effectively grinding scissors or other tools, sharp cutting edge.
2. Under normal circumstances, it does not need water cooling when grinding, and the sharpened blade is also very sharp.
3. The machine can grind a pair of scissors or pedicure knife in less than 1 minute. The product has the advantages of high efficiency, high cost performance, convenient carrying, low noise and beautiful appearance.
4. The machine can be used vertically or horizontally. The machine is equipped with 4 pieces of Emery wheel and 1 piece of leather polishing disc.
5. This machine supports forward or reverse rotation.
6. Products are widely used: can be used to grind hair clippers, hair clippers, pet scissors, pedicure knives, jade, carving knives, kitchen knives, meat knives, and other knife and scissors. The buffalo polishing disc can also be used to polish the blade.

Parameter:

Model:Sharpening machine
Voltage :220V 50-60Hz (do not support 110V)
Power :180W
Grinding disc size：150mm
Speed:400-3000rpm (adjustable)
Tool holder working angle :45°-85°
Net weight::5.4kg

Package Includes:

1 x Sharpening machine

Operating instructions:

Put the scissors to be grinded on the grinders bracket and adjust the Angle between the scissors mouth and the grinders before starting the grinders (the Angle is generally between 40 and 50), and then take off the scissors. Turn on the grinder switch. Place the scissors back on the rest by the waist. Using the middle and ring fingers of your left hand, gently push the scissors against the grinder. At the same time use the right hand to pull the scissors evenly to the right can.. The duration of each operation should not exceed 4 seconds. Slow time will have a bad effect on the high temperature of the scissors and may damage the edge. If you think it's not sharp enough or the Angle is not right. We can fine-tune the Angle of the Angle. Grind again... There is no annealing effect on grinding disc and scissors. Then use a thick cloth to wipe off the iron powder attached to the blade before testing. Sharpen pedicure knives and hair clippers. Electric shears need to stand up the machine to use very handy.

Safety and Care:

Each time when loading and unloading the grinding disc, we should pay attention to keep the plastic on the disc clean. If it is found that the plastic is absorbed by the four magnets on the plate with iron ends. You can use tape to hold the iron dust down. Then the grinding plate with a nail on the surface of the grinding plate under a white scratch is the front. You can't draw scratches on the reverse side... And the back of the disc should be wiped clean with a clean cloth. A spout was heard when the grinding disc was held in place by the four magnets to indicate that the grinding disc and the recluse disc had matched. No tools are needed to load and unload the millstones. You can dig the millstone with your fingers... Operators must pay attention to safety when using the machine.