Feature :

- LED DRL: Makes your vehicle more visible to other road users to increase your driving safety

- Completely sealed: Prevents moisture from being trapped inside the housing
- One-way vent: Drives out moisture and avoids lens misting

- Multi-surface reflectors: Increase light output & distance

- PC lens: Impact resistance for an enhanced driving experience in any environment.

Fits for :

- For 2006-2011 Civic Sedan(4-door)

  (Not fit to 2 door Models)

- OEM: 33151-SNA-A02, 33101-SNA-A02

Specification :

- Condition: 100% Brand New and High Quality

- Material: Plastic Housing / Polycarbonate Lens

- Color: Black Housing + Clear Lens

- Low Beam Bulb Type: 9006 / HB4 (bulbs not included)

- High Beam Bulb Type: 9005 / HB3 (bulbs not included)

Packing List :

- 1 Pair of LED DRL Headlights (Driver & Passenger Side)

Please Note :

Before you begin to adjust the light, make sure to check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.

1. 【Find the adjustment screws】Firstly, locate the adjustment screws on your vehicle.

2. 【Adjust the headlights individually】The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.

3. 【Adjust the vertical field】The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

4. 【Adjust the horizontal field】The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.

5. 【Test your results】

Condensation DOES NOT Mean a Product Problem 

It's normal that the condensation appears inside the headlights because of temperature differences, air pressure, etc, thus it is not the quality problem of headlights.

How to Remove Temporary Condensation

1. Check the vents to prevent blocking and switch on the low beam light for about 20 mins

2. Take the headlight bulb out and drive out moisture 

3. Put a silica gel packet in the housing to soak up moisture