Occasion: Body STRATOCASTER
mahogany - High-grade Gloss Finish -
ready for assembly
The holes for the screws are already drilled.
Produced by a luthier for a high-end project,
this body has received several coats of varnish and no longer requires any work,
sanding and varnishing have been carried out with the greatest care.
Sold second-hand but completely new, we offer this project currently being installed.
The cavities have been shielded, the jack and the claw installed with soldered wires.
There is just a small scratch (see the red circle in a photo), otherwise this bodysuit is magnificent.
Attention:
Thongs spacing: 56mm
The cavities are shielded.
All holes are drilled.
The neckplate with 4 screws is offered.
The output jack is installed and wired.
The claw is mounted.
The ground wire is installed.
Give free rein to your creative genius
to complete this project
which will become an exceptional and undoubtedly unique guitar!
Weight: 2.23kg
Prepared to receive three single microphones,
a bridge and electronics of your choice.
This replacement body is for
a FENDER or SQUIERSTRATOCASTER .
Building a guitar takes a little work, so know what you're getting into and make sure you have the right tools. This guitar body is designed to hold complete equipment but your parts may not fit, so the body or your parts may need to be modified.
No drilling for the bridge screws, you will have to drill the holes yourself but this gives you lots of options on the style of bridge you will use.
The photos represent the item you will receive.
This body is approximately 4.3 cm thick.
Weight: 2.23kg
Neck notch:
5.6cm wide
7.5cm long"
1.4cm deep.
Pickups: 3 singles
Bridge: STRAT tremolo
Jack output: 7/8 "classic mounting.
“High grade gloss” finish
Made in USA
This body, although sold second-hand, is new