Installs in seconds - No soldering or gooey electrical tape needed!

Separate the end of the wires to about 1”. Strip the insulation about 3/4” off each wire. Then feed the wires through the hole in the plug, and bend the bare ends back along the slots in the sides.

With very thin wires, you may kink up the wire ends a bit to ensure the best contact.

Then simply plug into your power track and you’re racing!

Works with virtually any 2-wire controller.

Designed and made in the USA.

Colors may vary. 

Also available in a 6-pack with 2 power pack adapter plugs. Perfect for adding variable power supplies to your AFX and AW track without any tricky wiring required. Please see our other listings!