Features:
Made of environmentally friendly plastic, 3D printing process, with sponge protection attached to the part of the body that fits
Support a variety of camera mounting methods, can be mounted on the top or bottom, can also be used as a hand-held take-off and landing
With 1/4 screw connection, support all panoramic cameras and sports cameras with 1/4 screw holes

Specifications:
Material: PLA
Net Weight: 50g
Applicable Model: for DJI Air 3 Drone

Package include:
1x Bracket Set

Note:
Does not include the drones and cameras.
Installation should pay attention to the location, the screws need to be tightened (loose will produce resonance shaking), but can not be too tight (too tight will blow up), storage and use of the temperature of -10-40 degrees, do not put in the car in the summer to store, more than 60 degrees is likely to lead to deformation.
This product must be hand-held take-off and landing or find a hollow frame in the middle as a landing support, be sure to turn off the downward vision obstacle avoidance before operation.