Yokomo 1/10 SD 2.0 Drift Chassis -KIT- SDR-020
The tuning drift car SD series, which realizes various specifications
by rearranging parts, evolves to the latest specification SD2.0. While
keeping the basic design of graphite double-deck chassis and gear drive
RWD down, the latest RWD drift style is further emphasized by thoroughly
reviewing the weight balance and changing the front Ackermann ratio.
- Variable transmission with selectable positive torque (4 gears) or reverse torque (3 gears)
- High-precision aluminum rear bulkhead
- Diff can be accessed simply by removing the rear bulk cap
- Rear traction can be adjusted with differential height adjustment
- Separate chassis structure that makes it possible to change the height of the bulkhead
- Rear- side servo mount that achieves a 3:7 weight balance
- Ackermann ratio setting that improves operability with the new steering block
- New lightweight slide rack
- Improved rear traction New rear hub carrier
- Graphite double-deck chassis designed with the rear load in mind for drift driving.
The front section deliberately adopts a resin bulkhead. By finishing the
front part in a light weight, it has acquired a moderate front ground
feeling and turning performance.
Newly designed steering block to optimize the Ackermann ratio and increase the steering angle
The lightweight slide rack rail held by 3 bearings also contributes to
the weight reduction of the front. The steering response is enhanced and
the handling is sharp
It achieves the maximum cutting angle with the kit standard, and also
supports deep drift angles. With almost parallel Ackermann ratio, smooth
movement is possible even on low-grip road surfaces such as P-tiles.
Equipped with a servo behind the steering link crank. In addition, it
supports the conventional bell crank system and front inverted servo
installation.
Main chassis with a slim silhouette overall. It has a lot of meat and is finished with supple characteristics as a whole.
The main chassis and the rear end of the upper deck are split to
increase the flexibility of setting the rear section. Good
maintainability.
The running battery is for short size Li-po only. The battery position
is set at the rear end, and the rear load is increased to gain traction.
The weight distribution is front 3: rear 7 suitable for RWD drift cars.
Designed to maximize rear tire traction by mounting the motor high on
the rear axle. The motor position can be rotated around the spur gear
axis.
The aluminum bulkhead has high precision and achieves high driving
efficiency. It is possible to choose between 3 gears (positive torque)
and 4 gears (anti-torque) by rearranging the gears.
A new type of rear hub carrier that is set to roll more aggressively by
reviewing the relationship between the axle and the suspension pin
position
Suspension that combines the standard aluminum vehicle height adjustable
oil damper with a special drift spring. The rear is equipped with a
progressive spring as standard that absorbs vibration and enhances the
feeling of grounding.