About certification:
We can only provide CE certification, there is no other certification can be provided, thanks for your understanding.
1. About the noise: all the gasoline machines are noisy, currently we did not test the decibel , but the noise is the same as the motorcycle, so it is a normal phenomenon.
2. The machine itself is lightweight, it can use on boat weight of 100kg or less , load-bearing 4 people, but the speed is certainly not the same whenone person on it or 4 people on it. Customer who has high expectations on speed, please be noticed.
3. It can be marched with inflatable boats, rubber boats or fishing boats.
4. Necessary: you have to prepare a boat-motor stand or Hanging board on your boat.
SKU: OT-028----(2.5kw/3.5HP 2-Stroke)
There are two pull starter included in the parcel(one is the machine, another one for spare)we don't supply wearing parts (pull starter)for free.
STRICTLY FOR PROFESSIONAL USE ONLY".
Two strokes 3.5 hp and 3.6 hp are controlled by the handle, which is operated by the clutch. There is no Neutral, only idle mode or low speed mode.
Specification:
Short Shaft: 40cm
Overall length: 92CM
Overall widteh:36.5cm
Overall height: 22cm
Transom height: 42cm
Full throttle perating range: 4000-5000r/min
Maximum output: 2.5kw(3.5HP)
Speed: 10km/h
Type: 2-stroke
Ignition system: CDI system
Starting system: Manual start
Staring carburetion system: Choke start]
Propeller mark: 7-1/45-A(inch)
The engine and the propeller ratio: 2:1
Recommended fuel: Regular unleaded gasoline
Fuel to oil ratio: 35:1 Please be suject to this version, and disregard the manual about this point
Gear ratio: 27/13
Maximum speed: 10 km / h
Built-in fuel tank: 1.3L
Fuel consumption per hour: 1.5L
When at normal cruising, the appearence of the senveth picture. Falling back the boat, the appearence of the outboard motor likes the eighth picture. Falling back the boat, you should drive slowly otherwise the boat will not stable. The outboard motor backet can revolve 360. Only in simple let the engine revolve 180 and the operation handle face back, the boat can fall back to drive.
Announcements:
After in the sea water or turbid water cruising
1. Use the fresh water cleaning the outboard motor
2. With the moderate velocity circulating the engine, cool off the water chanel with fresh water.
3. Before completely running out cooling water, don't put the outboard motor outside. Otherwise the water cam pass the exhaust port to enter the air cylinder, from that will cause the engine breakdown.
4. The engine should deposit in the aridity and ventilated well place,avoid exposing directly in the sunshine.
5. Before the long term storing,you should run out of the gasoline in the fuel tank.
SKU: OT-ML-132---(3.6HP 2-Stroke)
Two strokes 3.5 hp and 3.6 hp are controlled by the handle, which is operated by the clutch. There is no Neutral, only idle mode or low speed mode
Short Shaft: 40cm
STRICTLY FOR PROFESSIONAL USE ONLY
1. Start-In-Gear protection/clutch feature prohibits prop rotation while idling.·
2. Lift/Tilt feature for shallow water operation and convenience.
3. Features 360 degree steering rotation for reverse without gear shifting.
4. Superior engine water cooling system for improved engine performance.
5. Easy pull off engine cover with push button latch for instant motor access.
Product Description:
Features: Features 360 degree steering rotation for reverse without gear shifting .
Start-In-Gear protection/clutch feature prohibits prop rotation while idling .
Lift/Tilt feature for shallow water operation and convenience . Superior engine water cooling system for improved engine performance. Easy pull off engine cover with push button latch for instant motor access. Standard CDI ignition system for easy starting and improved performance. Vertical mount engine design for increased power, performance and durability. Superior carbonation system with primer bulb for increased efficiency.
Twist grip throttle handle and engine stop button for improved response .
Superior outboard anti corrosion system and anodes for increased durability .
Durable cast nylon plastic construction for superior corrosion protection .
Through the prop exhaust outlet for decreased noise and pollutant .
Black propeller or white propeller would be sent at random.
Shipping Weight: 21.4 pounds
SKU: OT-ML-279---(3.5HP 2-Stroke)
Two strokes 3.5 hp and 3.6 hp are controlled by the handle, which is operated by the clutch. There is no Neutral, only idle mode or low speed mode
Please Notice: STRICTLY FOR PROFESSIONAL USE ONLY
What you will receive is our new version of this boat engine
The trademark will be Yadao instead of Speeda.
Short Shaft:4 0cm
Overall length: 92CM
Overall widteh: 36.5cm
Overall height: 22cm
Transom height: 42cm
Full throttle perating range: 4000-5000r/min
Maximum output: 2.5kw(3.5HP)
Speed: 12km/h(four people)
Type: 2-stroke
Ignition system: CDI system
Starting system: Manual start
Staring carburetion system: Choke start]
Propeller mark: 7-1/45-A(inch)
The engine and the propeller ratio: 2:1
Recommended fuel: Regular unleaded gasoline
Fuel to oil ratio: 35:1 Please be suject to this version, and disregard the manual about this point
Gear ratio: 27/13
When at normal cruising,the appearance of the seventh picture. Falling back the boat, the appearance of the outboard motor likes the eighth picture. Falling back the boat, you should drive slowly otherwise the boat will not stable. The outboard motor backet can revolve 360. Only in simple let the engine revolve 180 and the operation handle face back, the boat can fall back to drive.
Announcements:
After in the sea water or turbid water cruising
1. Use the fresh water cleaning the outboard motor
2. With the moderate velocity circulating the engine, cool off the water chanel with fresh water.
3. Before completely running out cooling water,don't put the outboard motor outside. Otherwise the water cam pass the exhaust port to enter the air cylinder, from that will cause the engine breakdown.
4. The engine should deposit in the aridity and ventilated well place,avoid exposing directly in the sunshine.
5. Before the long term storing,you should run out of the gasoline in the fuel tank.
About certification:
We can only provide CE certification, there is no other certification can be provided,thanks for your understanding.
Pay Attention
1. About the noise: all the gasoline machines are noisy, currently we did not test the decibel , but the noise is the same as the motorcycle, so it is a normal phenomenon.
2. The machine itself is lightweight, it can use on boat weight of 100kg or less , load-bearing 4 people, but the speed is certainly not the same whenone person on it or 4 people on it . Customer who has high expectations on speed, please be noticed.
3. It can be marched with inflatable boats, rubber boats or fishing boats.
4. Necessary: you have to prepare a boat-motor stand or Hanging board on your boat.
Two strokes 3.5 hp are controlled by the handle, which is operated by the clutch. There is no Neutral, only idle mode or low speed mode
STRICTLY FOR PROFESSIONAL USE ONLY
Please Note:
There are two pull starter included in the parcel(one is the machine, another one for spare)
We don't supply wearing parts (pull starter)for free.
If you want buy one please contact us
Short Shaft:40cm
Description:
Overall length:92CM
Overall wideth:36.5cm
Overall height:22cm
Transom height:42cm
Full throttle perating range:4000-5000r/min
Maximum output:2.5kw(3.5HP)
Speed:10km/h
Type: 2-stroke
Ignition system: CDI system
Starting system: Manual start
Staring carburetion system: Choke start
Propeller mark:7-1/45-A(inch)
The engine and the propeller ratio:2:1
Recommended fuel: Regular unleaded gasoline
Fuel to oil ratio: 25:1 Please be suject to this version, and disregard the manual about this point
Gear ratio: 27/13
Maximum speed: 10 km / h
Built-in fuel tank: 1.3L
Fuel consumption per hour: 1.5L
Announcements
After in the sea water or turbid water cruising
1. Use the fresh water cleaning the outboard motor
2. With the moderate velocity circulating the engine,cool off the water chanel with fresh water.
3. Before completely running out cooling water,don't put the outboard motor outside. Otherwise the water cam pass the exhaust port to enter the air cylinder, from that will cause the engine breakdown.
4. The engine should deposit in the aridity and ventilated well place,avoid exposing directly in the sunshine.
5. Before the long term storing,you should run out of the gasoline in the fuel tank.
SKU: OT-MLLCR-567(Water-Cooling, 3.5HP 2 Stroke )
About certification:
We can only provide CE certification, there is no other certification can be provided,thanks for your understanding.
Pay Attention
1. About the noise: all the gasoline machines are noisy, currently we did not test the decibel , but the noise is the same as the motorcycle, so it is a normal phenomenon.
2. The machine itself is lightweight, it can use on boat weight of 100kg or less , load-bearing 4 people, but the speed is certainly not the same whenone person on it or 4 people on it . Customer who has high expectations on speed, please be noticed.
3. It can be marched with inflatable boats, rubber boats or fishing boats.
4. Necessary: you have to prepare a boat-motor stand or Hanging board on your boat.
Two strokes 3.5 hp are controlled by the handle, which is operated by the clutch. There is no Neutral, only idle mode or low speed mode
STRICTLY FOR PROFESSIONAL USE ONLY
Please Note:
There are two pull starter included in the parcel(one is the machine, another one for spare)
We don't supply wearing parts (pull starter)for free.
If you want buy one please contact us
Short Shaft:40cm
Description:
Overall length:92CM
Overall wideth:36.5cm
Overall height:22cm
Transom height:42cm
Full throttle perating range:4000-5000r/min
Maximum output:2.5kw(3.5HP)
Speed:10km/h
Type: 2-stroke
Ignition system: CDI system
Starting system: Manual start
Staring carburetion system: Choke start
Propeller mark:7-1/45-A(inch)
The engine and the propeller ratio:2:1
Recommended fuel: Regular unleaded gasoline
Fuel to oil ratio: 25:1 Please be suject to this version, and disregard the manual about this point
Gear ratio: 27/13
Maximum speed: 10 km / h
Built-in fuel tank: 1.3L
Fuel consumption per hour: 1.5L
Announcements
After in the sea water or turbid water cruising
1. Use the fresh water cleaning the outboard motor
2. With the moderate velocity circulating the engine,cool off the water chanel with fresh water.
3. Before completely running out cooling water,don't put the outboard motor outside. Otherwise the water cam pass the exhaust port to enter the air cylinder, from that will cause the engine breakdown.
4. The engine should deposit in the aridity and ventilated well place,avoid exposing directly in the sunshine.
5. Before the long term storing,you should run out of the gasoline in the fuel tank.
- We maintain high standards of excellence and strive for hundred percent customer satisfaction. Feedback is very important to us. We hope that you contact us immediately before you give neutral or negative feedback, so that we can address your concerns. It is impossible to address issues if we do not know about them!
