Features:

 

Completely sealed: Prevents moisture from being trapped inside the housing
One-way vent: Drives out moisture and avoids lens misting
Multi-surface reflectors: Increase light output & distance
PC lens: Impact resistance for an enhanced driving experience in any environment

 

Fits for:

 

For 2001-2011 Ford Ranger
OEM: 6L5Z13008BA, 6L5Z13008AA, 6L5Z15A201BA, 6L5Z15A201AA

 

Made of materials that meet or exceed OEM requirements
High & Low Beam Bulb: HB5 (Not included)
Turn Signal: 3457A (Not included)
Black Housing w/ Clear Lens

 

Package Included:

 

Pair LH (Driver Side) + RH(Passenger Side) Headlights + Corner Lights 

 

Tips:

 

(How to install):

 

1. Undo the screws, clips, or retainer springs that hold the headlight in place.

2. Disconnect the wiring from the assembly.

3. Detach the headlight from the vehicle to replace it with a new one.

4. Fit in the new headlight assembly.

5. Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.

6. Reconnect the wiring that was unplugged from the assembly.

7. Put back the grille and other components that you removed. Seal them back into place.

8. Test the new assembly. 

 

(How to adjust your headlight):

 

1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle.

2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light, you want to block. Covering the light assembly directly can damage the plastic lens.

3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

 

4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left 

adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.

       5. Test your results.