Product Description

DP 200 is a specialist air curing - dry film which provides a long lasting semi-permanent release coating. It is based on a high percentage mixture of silicone resins and provides a highly durable release film for many polymer types - natural and synthetic rubber and rotational moulding grades of Polythylene.APPLICATIONSCures on exposure to air and forms a semi-permanent coating which acts as an effective release agent in the rotational moulding industry. Also highly useful for moulding processes and materials where a durable - long lasting release film is required.Can be used as mould seal or as a base coat for the subsequent application of other Ambersil mould release agents.Spray a light - even coating from 9 - 12 inches (25 - 30 cm) and leave to cure for approximately 10 minutes at room temperature. Curing can be accelerated by heating at 110C for approximately 6 minutes. Re-apply as necessary

• Appearance : Clear - colourless liquid
• Odour : Solvent
• Specifications/Approvals : Rolls Royce Item 116061 - Approved Supplier176
• SG @ 25C : 0.7
• Pressure @ 25C : 4 Bar
• Discharge rate : 1.0 g/sec
• Temperature range : Operational up to 200C
• Curing time : Approximately 10 minutes at room temperature
• Can be reduced to approximately 6 minutes by heating at 110C
• Recommended solvents : Amberklene FE10 ME20 or L030
• Solubility : Soluble in solvents - insoluble in water
• Flammability : Classified as extremely flammable under current EC Regulations
• Flashpoint : Not applicable in sealed aerosol
• Packaging : 400 ml aerosol

STORAGEThe product may be stored at normal ambient temperatures and has a shelf life of not less than 36 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame.