Rear Windshield Wiper Arm Blade Set For Buick Encore 2013-2020 For Chevrolet Trax 2012-2020
Specifications:
Condition: 100% Brand New
Material: Plastic & Metal & Rubber
Color: Black
Fitment Type: Direct Replacement
Placement on Vehicle: Rear
Wiper Arm Length: 32.5cm
Wiper Blade Length: 24cm
Fitment:
Fit for Buick Encore 2013-2020
Fit for Chevrolet Trax 2012-2020
Fit for Vauxhall Mokka 2012-2019
Fit for Opel Mokka 2012-2019
Please check whether this item can fit on your car before purchasing.
Features:
1. Easy installation, perfect match for the your car.
2. Delivers smooth, quiet, clean, chatter free wiping.
3. Made of high-grade materials. Adapt to harsh environments.
4. Aerodynamic design significantly reduces drag, noise and wind lift.
5. Tension memory applies even pressure along the entire blade length.
6. Prevents ice and snow build-up from the exposure of metal/plastic components.
7. Surface paint treatment, anti-aging. To prevent the wiper turn into white in insolation.
8. The high‑tensile strength spring rate keeps the wiper blade in good contact with the glass.
9. High-quality rubber strip. Use high quality rubber, and advanced production technology. The surface of strip were processed by three special treatment.
Package Included:
1 x Rear Window Windshield Wiper Arm
1 x Rear Window Windshield Wiper Blade
Maintenance Guidance:
1. When raining, remove dust on the windshield surface, be sure to spray glass water, can not dry scratch.
2. There are other stubborn and hard dirt on the glass. It should be cleaned by hand. These things can easily make the wiper blade injury, leading to scratch the rain is not clean, serious, wiper motor will also be affected.
3. In the winter, should be clear with ice shovel seem on the surface of the windshield, so as not to aggravate the burden of wiper.
4. The correct cleaning wipers: especially sand, it is the main culprit of wiper wear. If you do not pay attention to cleaning at ordinary times, it will cause severe wear and tear of wipers.
5. Try to avoid high temperature insolation: summer high temperature will test the wiper rubber material, for a long time will cause deformation or lose elasticity.
Installation:
1. Joint the wiper arm with the cross-pillar, which is in the middle of the wiper blade.
2. Put in vertical direction. The wiper arm would be stuck in the blade.
3. Install the whole kit put in the window. Done.
Notes:
1. All dimensions are measured by hand, there may be small deviations.
2. No installation instruction included, professional installation is highly recommended.
3. Due to the lighting and screen settings, the real color may slightly different from the picture.
