Product Description

INDUSTRIAL DEGREASER FG is an innovative solvent blend that is excellent for use where rapid turnaround is necessary and low flash point solvents can be used. Dissolves and removes:

• Greases
• Oils
• Lubricants
• Adhesives and contaminants from:
• Equipment
• Machinery
• Motors and metal parts

• NSF A8 and K1 registered (N 140255 and 140250) for use in food industry
• Cuts through dirt and grease
• Fast evaporation to minimise downtime leaves no residues
• Easy 'in place' cleaning with minimal odour
• Non-corrosive and non-staining
• Safe on most plastics coatings and rubbers (always test prior to use)
• Aerosol fitted with a 360O Spray System for all angle use - even upside down

APPLICATIONS

• Electric motors & Mechanical brakes and clutches
• Air tools & Pumps
• Material handling equipment & Dies
• Generators & Air conditioners and compressors
• Wire ropes & Bearings
• General degreasing and oil removal & Fork lift trucks
• Sprockets & Moulds
• Chains

DIRECTIONS

• Can be used by:
• Spraying
• Immersion
• Dipping or Wiping

For tough soiling - apply product and agitate to loosen contaminants

• Apply liberally and allow excess to run off
• Air dry or dry with absorbent cloth. Repeat if necessary
• Test a small area prior to use to check materials compatibility. Do not use on sensitive electronic equipment
• Ensure adequate ventilation. Do not use on energised equipment
• Rinse with potable water. Allow to dry thoroughly and vapours disperse before reactivating system

TECHNICAL DATA

• NSF Registered - Category : Aerosol A8 + K1 (N 140255) : Bulk A8 + K1 (N 140250)
• Appearance : Colourless Liquid - Sweet Odour
• Specific Gravity (@ 20C) : 0.808
• Flash Point (closed cup) : 25C
• Boiling Range : 100-170 C
• Freezing Point : < -30 C
• Evaporation Rate (ether = 1) : 19
• Vapour Density (vs air = 1) : 4
• Kauri-Butanol Value : > 150
• Hildebrand Solubility Parameter (calc.) : 8.206
• Hydrogen Bonding Index (calc.) : 0.384
• Fractional Polarity (calc.) : 0.037
• Viscosity (@ 20C calc.) : 0.76 mPa.s
• Surface Tension (@ 25C est.) : 23 mN/m
• Plastics Compatibility : Safe On Most Plastics (Test Prior To Use)

STORAGE

The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame.