Surfaces should be completely clean and dry. If necessary use LTP Grimex. NB: It is important to remove any factory applied sealer or wax from the tiles before sealing.
Apply thinly and uniformly using a soft cloth, sealant applicator pad or sponge. Within 20 minutes, whilst the sealer is still wet on the surface, buff well using a clean dry cloth or buffing machine. Leave to dry for 4 hours and then on more porous surfaces apply a second coat using the same method.
It is important to remember to remove any excess from the surface and buff well between each coat.
Do not apply in temperatures exceeding 25°C.
Ensure underfloor heating is switched off.
Over applied sealer will dry leaving a greasy residue on the surface. To remove, apply white spirit or a little more sealer and then buff immediately.
Always test on an inconspicuous area first.
Treated areas should be dry enough to walk on after about 4 hours but will take 3 days to become fully resistant.