eBay

Use on 6v, 12v, 24v Systems

PROGRAMMABLE LED Battery charge / level indicator

NEVER be left WITHOUT WARNING that your Bike, Car, Caravan, Camper, RV, electrical equipment, RC model, Bait Boat, or even that battery powering your light in the shed, is going 'Flat'

This versatile unit can be used wherever you have a 24v, 12v or 6v lead-acid battery or charging system. One wire to battery positive, one to negative. We couldnt have made it simpler.

Check the specification!...............

Simple programming via single built in pushbutton
Unit can be set to operate on 6v, 12v, 24v DC. Settings retained after power off for 100 years!!!
Can be set to operate on one of 6 programmable 'maps'
Works with all Lead acid, fibre mat or gel cells, and all other batteries that operate within the set ranges
Protects and warns against Undercharging, Overcharging, and 'flat' batteries.
Tri colour (Red, Green, Yellow) 10mm LED with removeable bezel
Just 21mm behind 2mm thick control panel when mounted.
Single 14mm hole required for mounting. (10mm without bezel)
Unit will operate down to 3.7v and up to 30v.
Power Consumption : 10mA nominal, low power modes (modes 3 and 6 - just 500 microamps)
Multiple oversampling - unit takes 10+ readings to obtain greatest accuracy.
Built in hysteresis to prevent 'strobing LED' when unit is at changeover point.
Supplied with fitted connection leads
Comprehensive colour fitting instructions

The tri-colour LED will illuminate in different colours, as per the table below, to show the state of your battery.

            15v
13.2v
12.8
12.5
12.1
11.8
11.5
11.2
11
10.7
10.5
1
Red/
Gn Flash
Green
Yellow
Slow Yell
Fast Yell
Red
Red Slow
RedFast
2
Red/
Gn Flash
Green
Yellow
Slow Yell
Red
Red Slow
RedFast
3
Red/
Gn Flash
Green
Green 'Blink'
Yell 'Blink'
Red 'Blink'
Blank (No Display)
4
Red/
Gn Flash
Blank (No Display)
Yellow
Slow Yell
Red
Red Slow
RedFast
5
Red/
Gn Flash
Green
Slow Grn
Green Fast
Yellow
Slow Yell
Fast Yell
Red
Red Slow
RedFast
6
Red/
Gn Flash
Green 'Blink'

Yellow 'Blink'
Red 'Blink'
Blank
One of the 6 operating modes (1 - 6) may be selected by the user at installation time. The default applications are in the below table. The user may select the best mode for their application regardless of suggested use.
1
Battery  Voltage Monitor
‘Standard’ voltage indicator mode. Low distraction, minimum of colour changes in normal operation, suitable for vehicle use, such as motorcycles, cars, boats, campers, etc.
2
Vehicle Charge Indicator
Illuminates Green when under charging conditions, ie vehicle alternator is working. Yellow and red will show if battery is discharging.  IDEAL for on the move battery charge monitoring.
3
Vehicle Monitor (low current sby) Plus ‘Psuedo Alarm Fitted LED’
Great for motorcycles, and vehicles stored long term. When riding/driving  and charging, light will show green. 30 secs after charging stops (vehicle parked) unit will enter low current (500uA) mode to show battery status whilst vehicle in storage. LED will blink green, yellow or red to show stored state battery condition. Added benefit that LED blinking looks like a vehicle alarm. Negligable current (0.5mA) drawn from battery.
4
Charge Indicator (Stealth Mode)
Similar to mode (2) but not illuminated under normal charging conditions. IE, LED is blank in normal operation. Yellow and red illuminations will signal charging faults or discharging battery.
5
High Res 10 step voltage monitor
High resolution (Extra display modes) where maximum resolution is important, and colour changes  / flashing in operation are not distracting. (IE not on a vehicle dashboard).
6
Minimal Monitor (Low current)
Simple low current (less than 0.5mA) three colour battery status monitoring. Gentle ‘blink’ every 2 seconds inicates current state.  LED will be blank when battery below 10.5v

When using outdoors, install using sealant as per the included instructions.
Buy with confidence, from a UK Limited Company.  We have a no arguments return guarantee.
Check out our Ebay shop for other battery monitor models.

NON UK BUYERS :
Shipping : Please note that Ebay postage estimator (beyond our control) will often give a WILD range of dates for you to expect receipt of your unit. Economy post may often be with you in 6-10 days, but may on occasion take longer,

1	Battery Voltage Monitor	‘Standard’ voltage indicator mode. Low distraction, minimum of colour changes in normal operation, suitable for vehicle use, such as motorcycles, cars, boats, campers, etc.
2	Vehicle Charge Indicator	Illuminates Green when under charging conditions, ie vehicle alternator is working. Yellow and red will show if battery is discharging. IDEAL for on the move battery charge monitoring.
3	Vehicle Monitor (low current sby) Plus ‘Psuedo Alarm Fitted LED’	Great for motorcycles, and vehicles stored long term. When riding/driving and charging, light will show green. 30 secs after charging stops (vehicle parked) unit will enter low current (500uA) mode to show battery status whilst vehicle in storage. LED will blink green, yellow or red to show stored state battery condition. Added benefit that LED blinking looks like a vehicle alarm. Negligable current (0.5mA) drawn from battery.
4	Charge Indicator (Stealth Mode)	Similar to mode (2) but not illuminated under normal charging conditions. IE, LED is blank in normal operation. Yellow and red illuminations will signal charging faults or discharging battery.
5	High Res 10 step voltage monitor	High resolution (Extra display modes) where maximum resolution is important, and colour changes / flashing in operation are not distracting. (IE not on a vehicle dashboard).
6	Minimal Monitor (Low current)	Simple low current (less than 0.5mA) three colour battery status monitoring. Gentle ‘blink’ every 2 seconds inicates current state. LED will be blank when battery below 10.5v